707694
120
Verklein
Vergroot
Pagina terug
1/122
Pagina verder
- 120 -
ENGLISH
POSSIBLE TROUBLESHOOTING
In the event of problems the stove stops automatically and runs the shutdown process and the display shows text regarding
the motivation for the shutdown (see the various alarms below).
Never pull the plug during shutdown on account of malfunctioning.
Should it block, to re-start the stove you will need to allow the switch off procedure to take place (15 minutes
with an audible signal) and then press the key.
Do not turn the stove on again before checking the cause of the malfunction and CLEANING/ EMPTYING the crucible.
INDICATION OF POSSIBLE CAUSES OF MALFUNCTION INSTRUCTIONS AND SOLUTIONS:
AL1 black out (not a stove fault) (this occurs in the absence of a electrical power voltage over 5 seconds)
The stove has a ‘black out’ function. If there is an electrical power cut, for a time of less than 5 seconds, the stove will switch back
on and return to operating pre-black out.
If the time is greater, the stove will position in the black out alarm mode, resulting in the cooling phase.
A list of the various possibilities follow:
AL2 broken smoke probe (this occurs when the stove can no longer read the probe)
• Thermocouple broken
• Thermocouple disconnected
• Smoke temperature out of measurement range
AL3 hot smoke (this occurs when the smoke temperature exceeds a safe temperature)
• Blocked chimney ue
• Improper installation
• Stove blocked
• High pellet loading, check pellet regulation (TSC)
NOTE: the "hot smoke" message appears having surpassed the FIRST threshold alarm of 250° sending the stove in modula-
tion, only on reaching 270° will the stove go to alarm mode and switch off.
AL4 suction fault (occurs when the smoke motor is faulty)
• Smoke motor blocked
• Rotation sensor faulty
• Smoke motor faulty
• Smoke motor thermostat activation
AL5 no switch on (this occurs during the switch on phase when the smoke temperature does not exceed the minimum threshold)
• Probable glow plug fault
• Crucible dirty or too many pellets
Pellets are used up
• Check the pellet safety thermostat (automatic resetting)
• Blocked chimney ue
AL6 no pellets (this occurs when the pellets are used up)
• No pellets in tank
• Gearmotor faulty
• Pellet duct/auger blocked
• Low pellet loading, check pellet adjustment
AL7 thermal safety switch (this occurs when the safety thermostat, in contact with the tank, trips due to excess temperature in
the pellet tank)
• Excess pellet loading
AL8 no negative pressure (this occurs where the draft is insuf cient in the cold air suction tube)
• Cold air tube blocked
• Pressure switch faulty
• Clogged silicone tube
Stove status before black out Deactivation time under 10” Deactivation time over 10”
OFF OFF OFF
PRE-LOAD BLACK OUT BLACK OUT
SWITCH ON BLACK OUT BLACK OUT
START START RE-SWITCH ON STAND-BY
WORK WORK RE-SWITCH ON STAND-BY
FINAL CLEANING FINAL CLEANING FINAL CLEANING
STAND-BY STAND-BY STAND-BY
ALARM ALARM ALARM
ALARM MEMORY ALARM MEMORY ALARM MEMORY
120

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Italiana Camini Prima bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Italiana Camini Prima in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens als bijlage per email.

De handleiding is 2,41 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Italiana Camini Prima

Italiana Camini Prima Gebruiksaanwijzing - Nederlands - 28 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info