632874
30
Verklein
Vergroot
Pagina terug
1/31
Pagina verder
How Verro Works
iRobot Verro uses a powerful motor to
draw 80 gallons of water per minute
through the filter bag. This creates strong
suction at two inlet ports under the
robot that draws dirt and debris, such as
bacteria, algae, leaves, and even coins
into the filter bag where they are trapped.
The pump motor also drives two high-
pressure jets under the robot that loosen
dirt and attached particles, which are
then vacuumed up.
Verro uses the force of the water being
pumped through the robot to hold itself
against the surface it is cleaning and to
move along it.
Each time it changes direction, Verro
automatically alters it course slightly so
that it covers the entire bottom and sides
of the pool efficiently.
iRobot
®
Verro
model 300 Quick Start Guide
Instructional photos available at www.irobot.com/usetips
Tip
Clean the filter bag regularly. Verro uses
the force of the water pumped through
its filter bag to move properly. If the
filter bag is not kept clean, Verro will
not move or clean properly.
Tip
Store Verro in a dry place out of direct
sunlight at a temperature between
50 and 104 degrees Fahrenheit. The
Power Supply is water resistant, but not
waterproof and may be damaged by rain.
Important: Failure to properly store Verro
will result in loss of warranty.
Tip
iRobot recommends using the mesh
filter bag (included) when
the pool contains a significant quantity
of large debris (leaves, etc.), such
as when the pool is opened for the
season. The fine filter bag is ideal for
filtering small debris (algae, sand,
etc.) and for regular maintenance.
Tip
Periodically straighten the floating
power cord with the Detangler.
Tip
Verro’s Power Supply has an automatic
timer that shuts Verro OFF after
approximately two hours of operation.
When this happens, the power switch
will remain ON. To start another
cleaning cycle, switch the Power
Supply OFF and then back ON and
then press the reset button.
1
Uncoil the floating power cord and spread it over the surface of the water, ensuring that it is not tangled
or kinked.
6
Set the time control dial to 30 seconds.
2
Place Verro upside down in the pool and rock it from side to side to allow air to escape. Turn Verro over
and allow it to sink to the bottom of the pool so that the wheels rest on the bottom of the pool.
Warning: A Ground Fault Current Interrupter (GFCI) must be installed to
protect your electric outlet and prevent any possible electric shock.
7
Turn the Power Supply switch ON then press the reset button. The light on the Power Supply will
illuminate and Verro will start to clean your pool.
3
Place the Power Supply in a dry area at least 3.5 meters/12 feet from the pool.
5
Ensure that the Power Supply is at least 12 feet from the pool and that the power switch is OFF. Plug
the Power Supply into a GFCI outlet. Ensure the electric outlet has been properly grounded.
Never leave the Power Supply plugged in when Verro is not in use
4
Plug the floating power cord into the Power Supply. Be sure not to force the plug as it will only
go in one way.
30

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Irobot Verro 300 Series bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Irobot Verro 300 Series in de taal/talen: Engels als bijlage per email.

De handleiding is 4,4 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info