686578
30
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
344
NLA
S AVE THESE INSTRUCTIONS
(344NL) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2019
English
Page 30
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
NO DISPLAY/SPA
CONTROL UNIT
DOES NOT WORK
Spa is unplugged or off.
Control panel cable plug loose.
• Power failure.
• RCD tripped.
• RCD broken.
Ensure the spa is plugged and switched on.
Ensure the control panel cable plug is rmly
attached to the control base receptacle.
Check power source.
Reset the RCD.
Contact Intex Service Center.
HOUSEHOLD
CIRCUIT BREAKER
TRIPPED
Circuit breaker under rated.
Overloaded circuit breaker.
An electrical fault in the line.
Ensure correct circuit breaker rating.
Provide a dedicated circuit breaker feeding the
spa electrical outlet only.
Contact a qualify electrician to correct the
electrical fault.
NOT HEATING
PROPERLY Temperature set too low.
• Dirty lter cartridge.
Water temperature decreasing during
heater STANDBY mode.
Heating element failed.
Increase the temperature and attach the spa
cover.
Clean or replace the lter cartridge in time.
If heater is in STANDBY mode, press the ame
button twice to heat up the water to the set
temperature.
Contact Intex Service Center.
JET FUNCTION
DOES NOT WORK Jet pump is too hot. Turn off and unplug the spa. Let it cool down and
restart all over again.
If problem persists, contact Intex Service Center.
JETS OUTPUT ARE
WEAK Low water level.
Obstruction in the suction inlet inside
the tub.
Jet nozzles clogged or dirty.
Jet nozzles plumbing pipes damaged.
Add water between MIN and MAX level.
Ensure suction inlet is not covered or blocked.
Clean any dirt inside the jet nozzles.
Contact Intex Service Center.
JET AIR CONTROL
KNOB NOT
WORKING
Jet nozzles clogged or dirty.
• Jet air ow plumbing inside the spa tub
damaged.
Clean any dirt inside the jet nozzles.
Contact Intex Service Center.
FILTRATION PUMP
NOT WORKING • Dirty lter cartridge.
Filtration inlet and/or outlet clogged.
Filter pump motor failed.
Clean or replace the lter cartridge in time.
Check and clean ltration inlet and outlet
regularly.
Contact Intex Service Center.
WATER NOT CLEAN Cartridge assembly not properly
attached.
• Insuf cient ltering time.
• Dirty lter cartridge.
Improper water maintenance.
Filtration inlet and outlet clogged.
Ensure the cartridge assembly is properly
attached.
• Increase ltration time.
Clean or replace the lter cartridge in time.
Keep the spa water properly sanitized. Refer to
the chemical manufacturer’s instructions.
Check and clean ltration inlet and outlet
regularly.
PUMP
CONNECTORS ARE
NOT LEVEL
WITH THE SPA
CONNECTORS
One characteristic of PVC is that
it changes shape, which is normal. Elevate the pump with wood or another type of
insulated material to bring the pump’s connectors
level with the spa’s connectors.
TUB HAS A
STRANGE SHAPE Expanded internal air pressure by
strong sunshine. Do not expose the spa to direct sunlight for
extended period of time.
Check the air pressure and release air if
necessary. During very hot weather, you must
check to see whether it is necessary to release
some air. This is to avoid any possible damage
to the tub.
30

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Intex-PureSpa---28492-PS-BH-20

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Intex PureSpa - 28492 PS-BH-20 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Intex PureSpa - 28492 PS-BH-20 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,61 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Intex PureSpa - 28492 PS-BH-20

Intex PureSpa - 28492 PS-BH-20 Gebruiksaanwijzing - Nederlands - 25 pagina's

Intex PureSpa - 28492 PS-BH-20 Gebruiksaanwijzing - Deutsch - 34 pagina's

Intex PureSpa - 28492 PS-BH-20 Gebruiksaanwijzing - Français - 34 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info