311702
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
5019 512 10017
Ignis is a registered trademark of Whirlpool USA.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the
table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy
Label” refer to the programme “Coloured Cotton 60°C”.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household
conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
1. Close the drum flaps and check that they are
properly locked.
2. Add detergents and additives into the dispenser
to no more than the
“MAX”
level mark, as
follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3.
Turn the
programme selector knob
clockwise
to the desired programme.
4.
Turn the
temperature knob
to the required
temperature.
“Eco Wash” button
The wash time is extended and the water
temperature is reduced.
This function saves about 30% in energy without
compromising the excellent results of the wash.
“Half Load” button
Reduces the water consumption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
Especially suitable for lightly soiled or small loads
(reduces the quantity of detergent).
Not suitable for high temperature programmes.
“Rinse Hold” button
The laundry remains in the last rinse water,
without progressing to the spin cycle to avoid
creasing and prevent colours from changing.
This option is especially recommended for the
“Synthetics” or “Delicate” programmes.
This option is perfectly suitable if you wish to
postpone the spin or you don't wish to spin the
clothes.
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton 90 5.0 72 1.80 115
Cotton 60 5.0 72 1.15 115
Coloured 60 2.0 66 0.80 100
Coloured 40 2.0 66 0.40 100
Quick Wash + 1/2 Load 40 2.5 54 0.50 85
Synthetics + 1/2 Load 30 1.0 54 0.30 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)
eco
Note:
the programme selector stops on “ ”.
Terminate the “Rinse Hold” option.
Press the “Rinse Hold” button again; the
programme will terminate automatically with
the spin cycle corresponding to the previously
selected wash programme.
If you do not wish to spin the clothes, switch off
the appliance by pressing the
“On/Off”
button.
The pilot light goes out. Turn the programme
selector to the “Drain” position and switch on
the appliance.
Open the water inlet tap and select the desired spin
speed, turning the spin speed and
“On/Off”
knob
to the desired position (the indicated spin speed or
“No Spin”). The pilot lamp lights up.
During the running programme, the door cannot be
opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical
power failure occurs, the door unlocks
automatically after about 1 minute.
The programme selector knob is at “STOP”,
the pilot lamp lights.
1. Turn the spin speed knob to the Off position
”. The pilot light goes out.
2. Cancel the options by pressing the appropriate
buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine.
1. Turn the spin speed knob to the Off position
” to switch off the appliance.
The pilot light goes out.
2. Select the new programme, temperature and
options.
3. Turn the spin speed knob to the desired spin
speed to switch on the appliance.
The pilot light lights.
1. Turn the spin speed knob to the Off position
” to switch off the appliance.
The pilot light goes out.
2. Set the programme selector on “Drain”.
Turn the spin speed knob to the desired spin
speed to start the “Drain” programme.
Only open the door when the programme
selector is at “STOP” and the door is unlocked
(after approximately 1 minute).
After switching your washing machine on, it
does not start immediately: it needs some
seconds in order to lock the door, fill water and
then drum starts turning.
Spinning has an interrupted start-up: the drum
starts and stops running several times, to
improve spin efficiency and to better balance
the laundry.
At the end of the spinning cycle the drum goes
on reversing for some minutes: this helps you
unloading the laundry.
Do not exceed in detergents dosage: excessive
foam formation may prevent spinning.
The turning of the drum is stopped in several
steps of the washing cycle due to optimization
of energy consumption.
PROGRAMME START
DOOR LOCK
PROGRAMME END
SELECTING A NEW PROGRAMME, SPIN
SPEED, OPTIONS AFTER PROGRAMME
START
TO STOP, RESET A PROGRAMME BEFORE
THE END
NOTES AND INDICATIONS FOR USE
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ignis awv 516 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ignis awv 516 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Ignis awv 516

Ignis awv 516 Gebruiksaanwijzing - English - 15 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info