27
4
SELCALL/ALE OPERATION
ï Emergency selcall
The Emergency call allows you to broadcast an emer-
gency signal with own position information.
• Preparation for Emergency selcall
Sending a Selective Beacon call on several Selcall
channels, and check the propagation on each chan-
nel to select the channel of good signal quality. (p. 20)
• Sending Emergency selcall
q Push [
∫∫
] or [
√√
] to select the desired channel for
Emergency selcall.
w Push [CALL] momentarily to enter the Call menu.
e Push [
ΩΩ
CLR] or [OK
≈≈
] to select ‘EMER SEL-
CALL.’
• ‘SELCALL,’ ‘GPS BCON,’ ‘GPS POSN,’ ‘EMER SEL-
CALL,’ ‘PAGECALL,’ ‘STATUS CALL,’ ‘SEL BCON’ are
selectable.
r Push [
√√
] to select ‘ID,’ then edit ‘0,’ ‘0,’ ‘0,’ ‘0’ as no
specified ID or
select an intended ID.
• Last selected ID is displayed.
• Enter the 4-digits (or 6-digits depending on Initial set
mode setting) number of the desired ID using 10-key-
pad directly. Or push [OK
≈≈
] to enter ID selection, push
[
∫∫
]/[
√√
] to select the pre-programmed ID, then push
[OK
≈≈
] to fix the ID.
To send a group call, the last 2 digits to ‘0,’ ‘0.’
To send a all call, the last 3 digits to ‘0,’ ‘0,’ ‘0.’
t Push [
CCAALLLL
] for 1 sec. to transmit the Emergency
selcall.
• Before transmitting the selcall, verify ‘SelfID’ for your
own ID.
• While calling, push [CALL] to cancel the call.
• Other than AUS version
q Push [
EEMMGG
] momentarily to enter the Emergency
Call channel group.
w Push [
∫∫
] or [
√√
] to select the channel.
e Push [
EEMMGG
] for 2 sec. to transmit the Emergency
Selcall.
<Emergency Selcall menu>
After selecting the channel at step w, push
[OK
≈≈
] to
edit the Emergency selcall menu.
• Receiving Emergency Call
When a transceiver receives an Emergency Call with
your individual ID, it automatically responds by trans-
mitting. The receiving Emergency Call is stored in the
selcall memory.
After receiving a Emergency Call and push [
ΩΩ
CLR]
or [OK
≈≈
] to select the call, the following indication is
displayed.
