522287
34
Verklein
Vergroot
Pagina terug
1/35
Pagina verder
offered by Busse-Yachtshop.com
Total Time. The total time category indicates the total time the unit has been in use since shipped
from the factory. It is normal for some hours to appear in the total time when the unit is new due
to factory testing. While this is often of interest to the user, it is primarily a diagnostic tool for the
repair technician should the unit need service.
Sonar Beams. The second Diagnostic screen provides valuable information about the sonar
function of the 400TX. The three columns of information show the raw sonar signal as it is seen
by the unit.
This information is useful in both troubleshooting a potential fault, as well as aiding in the
transducer installation (for through the hull installations only).
The sonar diagrams indicate the returned signal of each sonar pulse transmission. By analyzing
these diagrams, the user can gain additional insight into the performance of the unit.
The diagrams show time delay (distance) on the vertical axis, and amplitude or strength of return
on the horizontal axis. An "amplitude" number shows the relative strength of each return signal.
The depth number shows the depth of water beneath the boat as measured by each of the three
beams.
With the boat stationary over a flat, consistent bottom, the sonar returns from the left and right
beams should be identical. Any discrepancy between these signals may indicate a problem with
the location of the transducer. (Often voids or irregularities in the laminated hull of a fiberglass
boat will block or degrade one or more of the sonar signals.)
By referring to this screen prior to permanently mounting a through-the-hull transducer, the
location can be adjusted until no visible loss is observed.
The diagram of the center beam cannot be compared to the left and right beams as this beam is
a different frequency and beam width. The diagram is useful in ensuring that the center beam is
present and of sufficient strength.
The depth of the water beneath the boat is shown for each of the three beams. In operation, only
the center beam is used to display this depth, however, the depth number is another means of
comparison.
When in diagnostic, two menus are available to the user: Depth Range, and Diagnostic. The
Depth Range menu can be used normally to control the range of information displayed in the
Diagnostic diagrams. The Diagnostic menu is used to exit the Diagnostic function and return to
the Start-Up screen.
34

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Humminbird 400TX bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Humminbird 400TX in de taal/talen: Engels als bijlage per email.

De handleiding is 0,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info