594352
5
Verklein
Vergroot
Pagina terug
1/70
Pagina verder
3
GB
CLEANER MAINTENANCE
Emptying the Dust Container
When the dust reaches the max level indicator on the container, empty the dust container.
IMPORTANT: To maintain optimum performance, do not allow the dust to sit higher than the
max level.
1. Release the dust container by sliding the dust container release button towards the front
of the cleaner. Lift the dust container from the cleaner main body. [14]
2. Before emptying the Dust Container, gently tap it against the side of a bin to release any
excess dust from the lter.
3. To empty the Dust Container, hold the Dust Container over a bin with one hand and use
the other hand to press the Dust Container Flap Opening Button to release the dust into
the bin. [15]
4. Close the Dust Container Flap and ret the Dust Container to the cleaner main body.
Cleaning the Washable Filters
The cleaner is tted with a pre-motor and exhaust lter. To maintain optimum cleaning
performance, regularly clean the lters. Remove excess dust from the lters by gently tapping
them against the side of a bin. The lters should be washed after every 5 container empties.
IMPORTANT: All bagless cleaners require regular lter cleaning. Failure to clean your
lters may result in air blockage, overheating and product failure. This may invalidate
your guarantee.
IMPORTANT: Regularly check and maintain the lters by following the lter maintenance
instructions, it is also recommended that you purchase new lters after every 3rd lter
wash. This will maintain your cleaners performance.
To access the pre-motor lter:
1. Empty the Dust Container as described in ‘Emptying the Dust Container. Then, keeping
the Dust Container Flap open:
2. Remove the pre-motor lter by rotating it clockwise at the bottom of the Dust Container. [16]
3. Separate the protective mesh from the lter. [17] Gently tap both the protective mesh
and the lter against the side of a bin to remove excess dust and wash both of them
under warm water. [18] Do not use hot water or detergents.
4. Remove excess water from the lter and leave it to dry fully before reusing. [21]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep cleaning
on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs removal. [1X]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal. [1Y]
Parquet Nozzle* – For parquet oors and other delicate oors. [1Z]
IMPORTANT: Do not use the Mini Turbo Nozzles on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
5. Once the lter is fully dry, reassemble the lter pack (protective mesh and lter) and ret
to cleaner.
IMPORTANT: Do not use the product without the pre-motor lter pack tted.
IMPORTANT: Always ensure the lter packs are fully dry before use.
To access the exhaust lter:
1. Unclip the exhaust grid from the rear of the cleaner. [19]
2. Separate the lter from the grid and wash the lter under warm water. [20] Do not use
hot water or detergents.
3. Remove excess water from the lter and leave to dry fully before reusing. [21]
4. Remount the lter into the grid and ret it to the cleaner.
Remember: Do not use hot water or detergents. In the unlikely event of the lters becoming
damaged, t a Genuine Hoover consumable. Do not try and use the product without a lter tted.
Removing a Blockage
1. Check if the Dust Container is full. If so refer to ‘Emptying The Dust Container’.
2. If the Dust Container is empty, but suction is still low;
A. Do the lters need cleaning? If so refer to ‘Cleaning the Washable Filters.
B. Check if there is any other blockage in the system - Use a rod or a pole to remove any
blockage from the tubes or hose.
C. Check for and clear any blockage in the Nozzle
WARNING - If the cleaner is used for a signicant period of time with a blockage, a thermal cut
out will switch the cleaner o to prevent overheating. The bag check indicator turn green once
the cleaner has switched o to signal that the thermal cut out has been activated. If this should
happen, switch the cleaner o, unplug and correct the fault. It will take about 45 minutes for
the cut out to automatically reset.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist before calling
your local Hoover service.
•  Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
•  Is the Bag over-filled? Please refer to ‘Cleaner Maintenance’.
•  Is the filter blocked? Please refer to ‘Cleaner Maintenance.
•  Is the hose or nozzle blocked? Please refer to ‘Removing a Blockage’.
•  Has the cleaner overheated? If so, it will take approximately 45 minutes to automatically
reset.
*Certain Models Only ** Certain models only, nozzles may vary according to model
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hoover SprintEVO SE60 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hoover SprintEVO SE60 in de taal/talen: Alle talen als bijlage per email.

De handleiding is 1,91 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info