This heater is equipped with SureSet
™
Digital Controls that provide the ability to set the temperature to the
exact degree desired. To operate, simply follow these instructions.
STEP 1: POWER
• Press the Power button ( ) once to start the heater on High
Power ( ), Continuous Run ( ) (Fig. 1). If left at this setting,
the unit will run continuously on High Power (1500 watts, 12.5
amps) and will not shut off until the unit is manually turned
off.
• Press the Power button ( ) again to change to Low Power ( ),
Continuous Run ( ). If left at this setting, the unit will run
continuously on Low Power (900 watts, 7.5 amps) and will not
shut off until the unit is manually turned off.
• Press the Power button ( ) a third time to turn the heater OFF.
NOTE: If operated at the Low setting, the heater will not provide as much heat output as in the High
setting, however, the Low setting will not require as much electrical current to operate. To avoid
overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
STEP 2: SET TEMPERATURE
• Press the Temp/Timer button ( ) until the Temperature Icon
( ) blinks. The current room temperature will appear (Fig. 2).
• Use the Up and Down arrow buttons ( ) to set the Desired
Temperature (Fig. 2).
• The Temperature Icon ( ) will stop blinking and the current room
temperature will reappear after the Desired Temperature is set.
• The heater will turn off shortly after the Desired Temperature is
reached and the Temperature Display will blink.
• The heater will turn back on when the room temperature drops
below the Desired Temperature. The Temperature Display will
then stop blinking and will display the current room temperature.
STEP 3: SET TIMER
NOTE: This function should only be set if you desire that the heater
be automatically shut off after a certain period of time (1 to 10 hours
from the time the function is set). Always set the Desired
Temperature prior to setting the Timer (see Step 2) so that the heater
will shut off at the Desired Temperature setting and not run
continuously.
• Press the Temp/Timer button ( ) until the Timer Icon ( ) blinks. The Hour Display will appear.
The Auto Off icon will also appear (Fig. 3).
• Use the Up and Down arrow buttons ( ) to set the heater operation time between 1 and 10 hours
(Fig. 3). Once the timer function is set the hour set will remain displayed until the time set runs out.
• The heater will automatically turn off when time runs out.
NOTE: If the Desired Temperature was set prior to setting the Timer function, the heater will cycle on and
off as per the selected Desired Temperature setting. To return to the Continuous Run Mode (Fig. 1), press
the Temp/Timer button ( ) a third time.
OPERATION
Fig. 3
Fig. 2
Fig. 1
Continuous Run Icon
Temperature Icon
Timer Icon
Auto Off Icon
