654258
4
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
-3- -4-
Body socket
"LEVEL" indicator lamps
"HIGH" (red) : "LOW" (green)
When the power switch is turned "ON,"
"LOW" or "HIGH" lights.
High/low selector button
Every time this button is pressed, the
potential power level is switched between
"HIGH" and "LOW." The vibration power
does not change.
Side plate
Touch this part and apply the head to
the skin, and the device will start to
operate.
"CHARGE" lamp
The lamp lights in red during charge,
and changes to green after completion
of charge.
Buzzer (selecting sound/warning
sound/ending sound)
Every time the switch/button is pressed,
a selecting sound can be heard.
If a warning sound can be heard during
use, it is a signal to indicate recharging.
When each mode exits, an ending
sound can be heard.
Body
Accessories
Charger Model: KH-182B
Rings (two)
Rings for fixing a cotton puff.
Power plug
Insert in an outlet to the roots.
Device plug
Stand
Cord
Batteries (built-in)
Nickel-hydrogen batteries
About the skin sensing function
The electric circuit operates with the skin in contact with the side plate and head.
Unplug
Check the head for any damage or deformation before use.
(Cause of skin damage)
Never use this product together with other beauty treatment devices at the
same time. (Cause of a failure or trouble)
Prohibited
Use only the attached charger. And, do not charge any other product
with the attached charger. (Possibility of an electric shock or ignition)
Never use this product if there is some injury or wound to your skin.
(Cause of skin trouble or pain)
Do not drop this product, or give it a strong impact.
(Cause of injury or a failure)
Do not wipe with benzene, thinner or alcohol, and do not spray insecticide.
(Cause of cracking, an electric shock, or ignition)
Make sure
Remove accessories such as earrings and necklaces, and contact lenses for
use. (Cause of an accident or trouble)
If there is any severe skin disorder or irregularity on your skin surface, or due
to downy hair, you may feel strong irritation in rare instances. In this case,
avoid using this product on that region. (Cause of an accident or trouble)
Do not keep the cotton puff on one part of your skin but always keep it in
motion. (Cause of skin trouble or poor physical condition)
Pull out the power plug and device plug without holding the cord.
(Cause of disconnection, an electric shock, short circuit, or ignition)
Make sure to pull out the power plug from the outlet unless used.
(Cause of an electric shock or fire by deterioration)
About the memory function
This device is equipped with a memory function for storing the potential power level
("HIGH" or "LOW") in memory.
In each mode (step 1 to 4), the power level ("HIGH" or "LOW") is stored in the memory
before an automatic stop or turning off the power switch.
The potential power level can be switched between "HIGH" and "LOW" by pressing
the "LEVEL" selector button during use.
Preparation before use
Since this product is not fully charged, charge before the first use.
Make sure to use 100-240V AC and use the attached charger.
How to charge
Names of parts and their functions (Fig. 1)
Head (titanium material)
Set a cotton puff and apply it to the skin.
This section vibrates during use.
Mode indicator lamp (orange)
When the power switch is turned "ON,"
"CLEANSING LAMP" flashes.
This lamp lights during use.
"MODE" selector button
Every time this button is pressed,
the mode is switched.
Side plate
Power switch (" ")
When this switch is pressed, it turns
"ON", and when this switch is pressed
again, it turns "OFF". Equipped with an
auto-off function, it will automatically turn
"OFF" if the device is not used for about
30 seconds in an "ON" state.
The standard charging time is 5 hours.
On a single charge, this device can be used approximately 10 times [when used at
the
"HIGH"
level in basic mode (three steps) in combination with
"
REFRESH
"
].
* Depending on the operating conditions, such as the ambient temperature,
the number of operating times may decrease.
During charge, the main body and the charger may become slightly hot, but
not an abnormality.
2. After the standard charging time (5 hours) has elapsed, pull out the charger from
the electric outlet and the main body. (Fig. 3)
1. Turn off the power, and connect the charger to the main body and outlet. (Fig. 2)
The charge lamp: lights in red during charge, and
lights in green after completion of charge.
Never use this product in places splashed with water or in damp places,
such as in a bathroom. (Cause of an electric shock or short circuit)
Do not insert or remove the power plug in/from an electric outlet
with wet hands. (Cause of an electric shock or short circuit)
It will not operate unless the side plate is touched and the head is applied to the skin.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hitachi CM-N8100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hitachi CM-N8100 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,68 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info