505730
4
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
AMPLIFIER FEATURE DESCRIPTIONS
2
MT OLYMPUS AMPLIFIERS:
A POWER LED indicates the powered up and turned on condition.
This is a unique series of amplifiers regarding channel stability and design.
All HIFONICS amplifiers feature a comprehensive diagnostic system, with speaker lead short circuit,
The COLOSSUS and COLOSSUS PRO are stable at 4/2/1-Ohm per channel and 4/2-Ohms bridged.
and amplifier DC faults indicated by the red “PROTECT” LED.
The BOLTAR and JUPITER are stable at 4/2-Ohms per channel and 4-Ohms bridged.
CAUTION: DO NOT OPERATE ANY AMPLIFIER BELOW THE INTENDED IMPEDANCE. YOU
The HERCULES and ATLAS is stable at 4/2/1-Ohm.
The input sensitivities for rated output powers are variable from 0.2V to 9V.
WILL CAUSE DAMAGE TO THE AMPLIFIER THAT WILL NOT BE COVERED UNDER THE
All crossovers are fully variable in their respective ranges.
WARRANTY PRINTED IN THE BACK OF THE MANUAL.
Crossover filters are 12dB/Octave.
FEATURES FOR BOLTAR / COLOSSUS PRO / JUPITER:
X-OVER:
-FULL RANGE: Bypasses all frequency adjustments except Subsonic.
-HP: High Pass operation uses Subsonic to cutoff the low frequencies and the FREQUENCY
adjustment can be used to create a sharper cutoff on the low end.
-LP/BP: Low Pass/Band Pass operation which allows for use of the Subsonic and Frequency
(Low Pass) shaping controls.
LOW PASS X-OVER:
-LP/BP STEREO 12dB/OCT: Stereo operation with a smooth 12dB/octave rolloff.
-LP DIRECT MONO 24dB/OCT: Bridged operation with a sharp 24dB/octave cutoff.
SUBSONIC FILTER: Low frequency cutoff variable from 15Hz to 150Hz.
PARAMETRIC EQ:
-X1 or X10 FREQUENCY MULTIPLIER: Multiplies frequency of enhancement in PARAMETRIC EQ.
-FREQUENCY: Variable enhancement from 40Hz to 400Hz at X1 or 400Hz to 4000Hz at X10.
-BANDWIDTH: Narrow to Wide range enhancements above and below the center FREQUENCY.
-CUT/BOOST: -10 to +10 enhancements centered at the FREQUENCY selected.
FREQUENCY: Variable from 40Hz to 400Hz at X1 and 400Hz to 4000Hz at X10 enhancement on
the multiplier. This FREQUENCY function varies based on the X-OVER selections described above.
PHASE: Variable time alignment from 0 to 180 degrees for both LEFT and RIGHT channels.
INPUT LEVEL: Variable from 0.2V to 9V.
FULL RANGE OUTPUT: Passes RCA signal through the amplifier unchanged by settings.
LINE INPUT: RCA Inputs.
FEATURES FOR JUPITER ONLY:
MODE: Internal routing of RCA signal. Selecting 2CH indicates RCA’s are being connected to Channel
1&2 Inputs and the amplifier will internally route signal to Channels 3&4. Selecting 4CH indicates RCA’s
are being connected to Channel Inputs on 1-4.
FEATURES FOR COLOSSUS / HERCULES / ATLAS:
LINE INPUT: RCA Inputs
FULL RANGE OUTPUT: Passes RCA signal through the amplifier unchanged by settings.
INPUT LEVEL: Variable from 0.2V to 9V.
PHASE: Variable time alignment from 0 to 180 degrees.
PARAMETRIC EQ:
-FREQUENCY: Variable enhancement from 30Hz to 100Hz.
-BANDWIDTH: Narrow to Wide range enhancements above and below the center FREQUENCY.
-BOOST: 0 to +10 enhancements centered at the FREQUENCY selected.
SUBSONIC FILTER: Low frequency cutoff variable from 15Hz to 35Hz.
LOW PASS FILTER: High frequency cutoff variable from 35Hz to 250Hz.
MODE (HERCULES/ATLAS ONLY):
-MASTER OUT: Factory setting for the switch location when using the amp alone. Also used when
linking a pair of HERCULES/ATLAS amplifier at 2-Ohms. When in MASTER OUT position, a single
RCA can be connected to the MASTER OUT RCA receptacle to provide signal to the SLAVE INPUT
on the SLAVE amplifier.
-SLAVE IN: Your MODE switch should only be in this position if you are linking a pair of
HERCULES/ATLAS amplifiers and this amp is the SLAVE. At that point the SLAVE amp will receive
the single RCA on the SLAVE IN. No other RCA’s can be connected to your amplifier other than
SLAVE IN when in SLAVE IN position.
BALANCED INPUT (COLOSSUS ONLY): DIN connection which is a step above the standard RCA
signal as it accepts from 0.4V to 18V.
These amplifiers feature two DIAGNOSTIC LED’s.
One monitors Short Circuits and Thermal Protection while
the second monitors Clipping status.
These amplifiers feature two DIAGNOSTIC LED’s.
One monitors Short Circuits and Thermal Protection while
the second monitors Clipping status.
BOLTAR / COLOSSUS PRO 2-CHANNEL AMPLIFIERS
JUPITER 4-CHANNEL AMPLIFIERS
HERCULES / ATLAS MONO AMPLIFIERS
COLOSSUS DUAL MONO AMPLIFIERS
LL
RR
HFR-G1
REMOTE
SUBSONIC FREQUENCY BANDWIDTH CUT/BOOST
FREQUENCY RIGHT LEFT INPUT LEVEL
PARAMETRIC EQ
PHASE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
FULL RANGE
X1 X10
FULL RANGE
OUTPUT
LINE
INPUT
15Hz 150Hz 40Hz 400Hz Narrow Wide -10dB +10dB
40Hz 400Hz 0 180 0 180 9V 0.2V
X1 X10
LP/BP
STEREO 12dB/OCT
MONO 24dB/OCT
LP DIRECT
HFR-G1
REMOTE
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HP LP/BP
CROSSOVER
PARAMETRIC EQ
PARAMETRIC EQ
HP
FULL RANGE
FULL
X1
X1
4CH
MODE
X1
X1
X10
X10
2CH
X10
X10
LINE INPUT
CH 3&4
CH 1&2
FREQUENCY FREQUENCY BANDWIDTH BOOST SUBSONIC LEVEL
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 15Hz 150Hz 9V 0.2V
40Hz 400Hz 40Hz 400Hz NARROW WIDE -10dB +10dB 9V 0.2V
FREQUENCY FREQUENCY BANDWIDTH BOOST LEVEL
4Ch
MONO MIX
OUTPUT
Ch1 Ch3
Ch2 Ch4
LL
RR
LEVEL PHASE BOOST BANDWIDTH FREQUENCY SUBSONIC LOW PASS
9V 0.2V 0 180 0dB +10dB NARROW WIDE 30Hz 100Hz 15Hz 35Hz 35Hz 250Hz
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
MASTER OUT
SLAVE IN
MODE
HFR-G1
REMOTE
PARAMETRIC BASS EQ
FULL RANGE
OUTPUT
MASTER
OUT
SLAVE
IN
LINE
INPUT
LL
RR
LEVEL PHASE BOOST BANDWIDTH FREQUENCY SUBSONIC LOW PASS
9V 0.2V 0 180 0dB +10dB NARROW WIDE 30Hz 100Hz 15Hz 35Hz 35Hz 250Hz
DIAGNOSTIC
RED-SHORT CIRCUIT
AMBER-THERMAL
RED-CLIP
AMBER-NEAR CLIP
GREEN-PRE CLIP
HFR-G1
REMOTE
BALANCED
INPUT
PARAMETRIC BASS EQ
FULL RANGE
OUTPUT
LINE
INPUT
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Hifonics MT OLYMPUS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Hifonics MT OLYMPUS in de taal/talen: Engels als bijlage per email.

De handleiding is 6,89 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info