811993
4
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
4
The minimum dimensions are (see drawing):
D 50 cm
E 30 cm (from inner edge firebox opening).
Rückwand: rear wall Seitenwand: side wall
Unterlagsplatte: floor protector
Strahlungsbereich: radiation area
Floor protection slabs (support slabs) are available from our
accessories program and can be ordered from your specialist
stove dealer if required.
5. wood stove operation
The wood stove must only be heated by adults. Ensure that
children never stay alone around the chimney stove. (Do not
leave the wood stove without supervision for any length of
time). The wood stove must only be used in accordance with
this Operating Manual.
Please observe the safety instructions shown in Chapter 2.
5.1. Suitable fuels
The stove is suitable for low-smoke fuels. The fuels
approved for combustion are listed on the Equipment Sheet.
Note! Wood is not a slow-combustion fuel so that
continuous heating of the fireplace with wood overnight is
not possible.
Note:
Never use waste such as wallpaper, chipboard offcuts,
plastic materials or impregnated wood for heating!
5.2. Adjusting the combustion air damper
The correct setting of the combustion air damper of your
wood stove can be found in the enclosed Equipment Sheet.
Please adhere to these recommended settings to optimally
utilise the heating energy of the fuel, to save fuel and to
protect the environment.
Combustion air
1 = primary air I through the grate
2 = primare air II flows onto the fuel in a horizontal dir.
3 = secondary air / air wash system
pre-heated air from above is the main combustion
air for wood
5.3. Initial start-up of your wood stove
Prior to initial start-up remove any adhesive labels and all
accessory components from the ash pan or the firebox, this
also applies to any transport locks that may have been used.
On models with draft baffle plates made of ceramic fibre or
vermiculite please check if these plates are located in their
anchorages (these could have slipped from their position as a
result of the transport or the installation of the chimney
stove). Otherwise these plates must be carefully hooked into
position (see Equipment Sheet).
In the case of chimney stoves with ceramic tiles the warming
compartment tiles must be placed in the warming
compartment. The ceramic tiles should be wiped clean with a
dry cloth.
For initial heating, carefully charge the wood stove with fuel
and “burn in” with a low flame. All materials must slowly
get accustomed to the heat development. By careful initial
heating you will avoid cracks in the insulating bricks, paint
damage and material distortion. Any smell developing
through re-drying of the protective varnish will disappear
after a short time.
5.4. Lighting and heating
Initially place 2 to 3 wood billets (approx. 1.5 to 2.0 kg) on
the firebox floor or grate, uncoated paper, cardboard or a
lighting cube on top, followed by brushwood, firewood or
pieces of briquettes. All existing air control dampers must be
fully opened. After lighting, close the firebox door. After
this, set the air control dampers as specified in the enclosed
Equipment Sheet.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Haas-Sohn Bench modules bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Haas-Sohn Bench modules in de taal/talen: Engels als bijlage per email.

De handleiding is 0.44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Haas-Sohn Bench modules

Haas-Sohn Bench modules Gebruiksaanwijzing - Deutsch - 6 pagina's

Haas-Sohn Bench modules Gebruiksaanwijzing - Français - 6 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info