724186
3
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
3 OfficeConnect OC20 Access Point | Installation Guide
Installing the Access Point
The OC20 access point ships with a ceiling rail adapter and an
AP-220-MNT-W1W mount bracket. Additional ceiling or wall
mount kits are sold separately as accessories.
Using the Ceiling Rail Adapter
The included ceiling rail adapter can be used to attach the OC20
access point to a 9/16” or 15/16” ceiling rail.
1. Pull the necessary cables through a prepared hole in the
ceiling tile near where the access point will be placed.
2. Place the adapter against the back of the access point with
the adapter at an angle of approximately 30 degrees to the
tabs (see Figure 3).
3. Twist the adapter clockwise until it snaps into place in the
tabs (see Figure 3).
Figure 3 Attaching the Ceiling Rail Adapter to the AP
4. Hold the access point next to the ceiling tile rail with the
mounting slots at approximately a 30-degree angle to the
ceiling tile rail (see Figure 4 and Figure 5). Make sure that
any cable slack is above the ceiling tile.
5. Pushing toward the ceiling tile, rotate the access point
clockwise until the device clicks into place on the ceiling tile
rail.
Figure 4 Mounting the Access Point to a 15/16” ceiling rail
Figure 5 Mounting the Access Point to a 9/16” ceiling rail
Using the AP-220-MNT-W1W Bracket
The included AP-220-MNT-W1W bracket can be used to mount
the OC20 access point to a wall.
1. Begin by attaching the bracket to the wall as shown in Figure
6 or Figure 7.
a. Install any necessary wall anchors. Wall anchors are not
included in the package.
b. Align the screw holes in the bracket with the previously
installed anchors or demarcated screw points.
c. Insert the screws to secure the bracket. Screws are not
included in the package.
Figure 6 Attaching the Bracket to a Wall
Figure 7 Attaching the Bracket to a Wall (Alternate)
2. Attach the AP to the secured bracket as shown in Figure 8.
a. Align the AP with the bracket, placing the AP so that its
mounting tabs are at an angle of approximately 30
degrees to the bracket.
3. Pushing toward the wall, rotate the AP clockwise until it
clicks into place (see Figure 8).
Service to all Hewlett Packard Enterprise access points
should be performed by an AMCP certified technician or
similar.
The installer is responsible for securing the access point onto
the ceiling tile rail in accordance with the steps below. Failure
to properly install this product may result in physical injury
and/or damage to property.
AP-130_003
AP-130_006
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw HP OfficeConnect OC20 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van HP OfficeConnect OC20 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,01 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info