625749
5
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
GENERAL DESCRIPTION
Thank you for choosing this GYS product which has been designed with great care. To get the best out of
your machine, please read the following instructions carefully, and keep for future reference.
The GYSTARTs are designed to start vehicles with liquid or gel electrolyte lead-acid batteries and also charge
liquid or gel electrolyte lead-acid batteries. They are for use on 12V or 24V batteries with a capacity
according to the table below :
GYSTART
724E
924-230
1224T
Charge
20>1000 Ah
30>1100 Ah
65>1350 Ah
Start
45>200 Ah
45>250 Ah
60>300 Ah
ELECTRICITY SUPPLY
This device must be plugged into an EARTHED power supply with the following characteristics :
GYSTART
724E
924-230
1224T
Voltage
230V single ph.
230V single ph.
400V 3 ph.
Protection
16A
40A
16A
Recommended cable section for use on extension cables: 3 x 2.5 mm² (4 x 2.5 mm² for the 1224T).
USE IN STARTING MODE (START)
Prior precautions
Do not disconnect the battery from the vehicle. If the battery is disconnected it can lead to information being lost
and possible failure in starting the vehicle.
Connecting and disconnecting
Switch off the product by selecting position “0”.
Connect the clamps: red to + terminal, black tobattery terminal. Select the correct voltage 12 or 24 V
for the battery.
NEVER disconnect the battery from the vehicle
Switch on the product by selecting “I”
Proceed to pre-charge (if necessary) for a few minutes with a current of about 1/5
th
of the battery’s capacity.
Sit behind the steering wheel in order to activate the remote control switch and the ignition at the same time.
A 5 second period is usually enough to start. Repeat the operation if needed.
When the engine’s motor starts, release the remote control switch and switch the device off - position « O ».
Disconnect the clamps from the battery.
In « Electronic Control » position, Gystart protects the on-board electronics and avoids overvoltage
( : <14,8V : <29,6V). In Manual position, this protection is not activated.
USE IN CHARGING MODE (CHARGE)
Prior precautions
Choose a sheltered area with suitable ventilation.
Remove the battery caps (if present) and ensure the liquid level (electrolyte) is correct. Add some
distilled water if necessary. Carefully clean the lugs and terminals of the battery.
Check that the capacity (Amps per hour) and the voltage (Volts) are compatible with your charger.
Connecting and Disconnecting
Switch off the product by selecting position “0”. Then plug into the mains supply and turn the charge
current potentiometer to the lowest setting.
Select the correct voltage 12 or 24 V for the battery.
Connect the clamps: red to + terminal, black tobattery terminal.
Make sure you get good electrical contact.
Select the charging mode using the switch :
“Electronic control”: when the charging process is over, a light will illuminate.
“Manual mode”: stop the charging process when your battery starts to boil.
Be careful of explosive gas, avoid
flames or sparks.
Switch on the product by selecting “I”
After one minute of charge adjust the charging current using the control knob.
5
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gys GYSTART 724E bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gys GYSTART 724E in de taal/talen: Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 0,63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Gys GYSTART 724E

Gys GYSTART 724E Gebruiksaanwijzing - Nederlands - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info