629292
42
Verklein
Vergroot
Pagina terug
1/46
Pagina verder
PX Version 5.0 - QX/RX Version 4.51 Installation Manual – Issue F
- 42 -
Introduction
The Dual Comm module, GSM module and the PSTN module may be used with any Guardall control
panel.
Feature Implementation
Transmission Voice and Data
Frequency Band Dual Band EGSM900 and EGSM1800
Transmit Power Class 4 (2W) for EGSM 900MHz
Class 1 (1W) for EGSM 1800MHz
Data 9.6Kbps
Supported SIM card 3V cards
There are a number of important points to consider when using one of the new module types with an
existing panel:
1. All previous communicators were designed for use within the panel case and consequently they
were designed with no tamper switch. The GSM/Dual comm module is intended for use outside
the panel case, and so needs a case tamper. The GSM/Dual comm module case tamper is
recognised from panel v4. If the GSM/Dual comm module used with earlier panel versions it is
recommended that line fault monitoring is enabled to act as a substitute for the tamper sensing.
2. The Dual comm module functions are programmed using the DIL switches. Future versions of the
firmware will include additional menu options for GSM programmable functions.
The latest firmware release is V4.52c. This is necessary to enable older panel versions to recognise
the module and allow access to the appropriate programming menus.
Installation
Special care is required when installing the GSM module or Dual Comm module;
1. Avoid placement on metal surfaces to ensure good radio performance.
2. To minimise GSM transmission interference, route all cables away from the GSM antenna.
3. If the system includes Audio Modules ensure that there is at least 3m between the Audio
Module(s) and the GSM/Dual Comm module.
4. The maximum recommended XiB bus cable length between the power supply and the GSM/Dual
Comm module is approximately 80m. This distance may be doubled if two cable cores are used
for the power connections. This restriction is based on the peak current requirement of 180mA
under poor signal conditions.
5. Insert a valid SIM card into the slot provided in the GSM engine. SIM code password protection
must be disabled.
42

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Guardall RX bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Guardall RX in de taal/talen: Engels als bijlage per email.

De handleiding is 1,16 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Guardall RX

Guardall RX Gebruiksaanwijzing - English - 46 pagina's

Guardall RX Installatiehandleiding - English - 46 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info