569628
5
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
Radio Reception
Switch the radio on with the button
RADIO ON.
The illuminated pointer DIAL 6 serves as
'on' indicator.
Select the waveband with the BAND switch:
FM = VHF
MW = Medium Wave
LW = Long Wave
Tune to stations with the rotary control
TUNING.
Adjust the volume with the rotary control
VOLUME.
Switch the radio off with the button
RADIO/ALARM OFF.
Aerials
For receiving MW and LW stations there is
a ferrite rod aerial inside the set.
Rotating the unit slightly can improve
reception.
The wire aerial at the back of the set is
used for VHF (FM) reception.
Position the wire aerial so that optimum
reception is obtained.
Setting the clock time
Press the TIME button and hold it pressed.
Set the clock time with the 1 and 22
buttons:
Fast forward with the 22 button.
Slow backward with the 1 button.
Release the TIME button.
Indicating the seconds
Press the SNOOZE button and hold it
pressed.
The display shows the unit digit of the minutes
and the running seconds, e.g.: at 12:15
hours, 20 seconds –> indication 5:20.
Setting the alarm time
Your Sonoclock 42 allows you to set two
alarm times (e.g., for two different persons).
Set the ALARM 1/2 switch to
alarm time 1
(
ALARM 1
) or alarm time 2
(ALARM 2).
Select the required alarm function (radio
alarm or sound signal alarm) with the switch
ALARM /ɷ/OFF.
The corresponding light dot on the display
shows which alarm time can be set:
ALARM 1 6 =
alarm time 1
ALARM 2 6 =
alarm time 2
Press the ALARM button.
The display shows the present alarm time.
Press and hold down the ALARM
button
and set the alarm time with the
1 and 22
buttons (in the same way as the clock time).
Note:
If the ALARM 1/2 switch is set to
position ALARM 1+2, it is not possible to
display or to set the alarm times.
8
Sonoclock 42/42 Q page 8
GB
POWER SUPPLY CLOCK RADIO
Connecting the unit
The unit is designed to operate from a mains supply
of 230 V, 50 Hz~.
When the set is connected for the first time or after a
power failure (without standby battery
fitted), the
display flashes to indicate that the clock
and, if
necessary, the alarm time (s) should be set.
Standby-battery – mains failure
If a standby battery is fitted, the clock will continue to
operate during mains failure. However, the display will
not be illuminated, the radio does not work and the
alarm will not sound unless the mains supply is restored
within 59 minutes of the preset alarm time (if so, the
radio will switch on or the alarm tone will sound).
Insert a 9 V alkaline battery (IEC 6 LF 22) into the
battery compartment on the bottom of the unit.
Insert the battery only after the unit has been connected
to the mains in order to prevent unnecessary drain.
We recommend that the battery is replaced after
approx. 1 year.
If the clock radio is to be disconnected for a long
period, the standby battery should be removed, as it
would otherwise discharge too quickly and may leak.
Note on Environmental Protection
Do not throw exhausted batteries in the
household refuse.
Hand over the old batteries to your dealer or
public collecting points when buying new ones.
Note:
The unit remains connected to the mains
even when it is switched off.
The unit is only fully isolated from the mains if the
mains plug is removed from the wall socket.
Important note for users in the U.K.:
When fitting a mains plug, follow the instructions
on page 2.
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Grundig Sonoclock 42 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Grundig Sonoclock 42 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Grundig Sonoclock 42

Grundig Sonoclock 42 Gebruiksaanwijzing - Deutsch - 6 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info