637253
4
Verklein
Vergroot
Pagina terug
1/29
Pagina verder
English
English
INNOVATION & TECHNOLOGIE
6 7
Batteries and / or cells that are not expressly approved by the manufacturer for the
charging currents occurring during charging with this charger.
Already fully charged or hot, or not completely empty cells or batteries.
Batteries or cells with integrated charging or disconnecting device.
Batteries or cells that are installed in a device or that are electrically connected to oth-
er components.
To avoid short circuits between the banana plugs tted to the charge leads, please al-
ways connect the charge leads to the charger and only then to the battery! When discon-
necting, proceed in reverse order.
When charging a transmitter, an interruption of charge can - even for short periods -, let
the charge voltage rise in such a way that the transmitter is destroyed by the overvoltage
immediately. Risk of re!
Notes on batteries handling
Batteries, and also individual cells are not toys and should be kept out of the
reach of children.
Before each use, check the proper condition of the battery. Do not use defective
or damaged cells / batteries.
Overcharging and deep discharge lead to irreparable damage to the cells and damage
permanently the capacity of the battery.
Never store batteries uncharged, discharged or partially charged for long periods. Be-
fore storing batteries charge them and from time to time check charge status. NiMH cells
should be 1 V per cell and Lilo / LiPo cells should never be less than 3 V per cell, in order
to achieve an optimum service life.
Overcharging also damages the capacity of the battery. Therefore do not charge any hot
or charged batteries again.
High power charge and discharge shorten the life expectancy of the battery. Therefore,
do not exceed the rates stated by the manufacturer.
Lead-acid batteries are not high power rechargeable. Never exceed the maximum charge
rate stated by the battery manufacturer.
When buying batteries ensure good quality, rst charge new packs at low rates, and work
up gradually towards higher currents.
Charge the battery just before you want to use them, the batteries are at their most pow-
er.
Rechargeable batteries / cells must not be heated, burnt, short-circuited or overloaded
with excessive or reversed polarity currents.
Batteries cells connected in parallel with combination of old and new cells, different fea-
tures as capacity and voltage, made by different manufacturers, brands or types should
not be used.
A built-in battery in a device should be removed whenever the device is not used. Always
turn off equipment after use to avoid deep discharge. Recharge the batteries just for the
right time.
The battery to charge should be placed when charging on a non-ammable, heat re-
sistant and non-conductive pad! Also ammable or highly ammable materials must be
placed away from the charging station.
Batteries must be charged only under supervision. Observe the maximum specied
charge rate for the specic cell type. Charge current must never be exceeded.
Should the battery heat during charge to more than 60 ° C, the charge must be stopped
immediately and the battery must be cooled to about 30 ° C.
Never charge batteries that are hot or not discharged to the rated discharge voltage.
No changes should be made to the batteries. Never solder or weld directly to the cells.
Released electrolyte is corrosive, not allow contact with skin or eyes. In an emergency,
rinse immediately with plenty of water and then consult a doctor.
Suitable extinguishing media are extinguishing blankets, CO2 estinguishers and sand.
The valve openings of the cells must not be blocked or sealed in any case, for example
by soldering. When soldering do not exceed a temperature of 220° C and for a period not
longer than 20 seconds.
To avoid deformation, do not produce an excessive mechanical pressure.
If a battery is overheated, proceed as follows:
Disconnect the battery and place it on a non-combustible surface (stone oor) until it has
cooled. Never keep the battery in your hand to avoid the risks of re and / or explosion.
Protect batteries from vibration, and do not expose to mechanical stresses.
When charging and during operation of the batteries, they can generate explosive gas
(hydrogen), be careful with adequate ventilation.
Never short circuit the batteries. This might cause re and / or explosion!
Batteries may explode or burn through a defect. We therefore recommend that all lithium,
NiCd and NiMH batteries, should be charged in a LiPo safety case Order Nr. 8370 or 8371.
Do not open batteries, chemical burn danger.
NiCd or NiMH battery packs perform their best by rst individually all cells are dis-
charged separately and only then the entire battery pack is charged. Discharging should
be done by the charger cell by cell.
Make sure that the charge-discharge are done properly.
Charging single NiCd or NiMH cells or batteries with 1 ... 4 cells, can be difcult
for the automatic shut-off. Since the onset after the full load point voltage drop is
not very pronounced, the automatic shut-off cannot or do not respond properly.
The correct operation cannot be guaranteed in this case. Be sure to check through multi-
ple, monitored test charges, if a proper shutdown occurs for the batteries you are using.
There is a serious re and / or explosion risk!
Capacity and use time
For all current sources applies: The capacity decreases with every charge. At low temperatures
the internal resistance increases reducing the capacity. As a result, the ability to provide power and
holding the voltage can be reduced.
Frequent charging and / or discharging programs can also lead to a gradual reduction in capacity.
However, current sources should be reviewed at least every 6 months on their capacity, and re-
place them if there is a signicant loss of capacity.
Use only genuine Graupner batteries!
Disposal of waste batteries
Every consumer is legally obliged under the German battery ordinance to return all used
and exhausted dry and rechargeable batteries.
Disposal in the household waste is prohibited. Old batteries can be brought to the public
collection points or given at our retail outlets and wherever batteries of the same type are sold. You
can return used batteries sent by us to the following address:
Graupner|SJ GmbH
Service: Gebrauchte Batterien
Henriettenstrasse 96
D-73230 Kirchheim unter Teck
You make a signicant contribution to environmental protection!
4

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Graupner-POLARON-EX-1400---GR-S2018

Zoeken resetten

  • Mijn LiPo accu’s laden niet helemaal opgeladen met de Polaron 1400EX, lijkt wel of ze niet worden afgesloten. Gesteld op 22-5-2020 om 09:41

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Graupner POLARON EX-1400 - GR-S2018 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Graupner POLARON EX-1400 - GR-S2018 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info