354217
7
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
Instructions for Use
17
Few hours before defrosting set the thermostat to position 7,
so that packages are well frozen. Reset the thermostat to
STOP (0) position and disconnect the power supply. Empty
the freezer and take care that the packages remain frozen.
Leave the door open for a while so that you can easy scrape
off the frost. Use the plastic scraper but be careful not to
damage the inner surfaces of the freezer.
Wipe up the scraped frost and ice before it is completely
defrosted.
Avoid using defrosting sprays, as they may cause damage
to the plastic parts and may be hazardous to health.
Cleaning the Appliance
Disconnect the power supply before cleaning the
appliance.
Do not use coarse or aggressive cleaning agents as you can
damage the surface.
Be careful to remove any cleanser agent remaining after
cleaning.
Clean the exterior with water and detergent.
Varnished surfaces are cleaned with soft cloth and an
alcohol based cleaning agent (for example glass cleaners).
You may also use alcohol (ethanol or isoprophylic alcohol).
The application of abrasive and specially aggressive
cleaners, such as the stainless steel cleaners, is not
appropriate for the cleaning of plastic and coated parts.
Parts made of stainless steel should be cleaned with special
agents for stainless steel. Use a soft cloth and apply a thin
layer of detergent onto the surface.
Remove the detachable accesories in the interior of the
appliance and clean it with water and liquid detergent.
Plastic parts cannot be washed in washing machine.
Wash the interior of the appliance with lukewarm water, in
which you added one or two spoonfuls of vinegar.
Every now and then wipe the condenser on the rear wall.
Use soft non-metal brush or vacuum cleaner.
Do not forget to clean also the defrost water receptacle
above the refrigerator compressor (do not remove the
receptacle).
After cleaning, connect the appliance to power supply and
reload the packages.
Switch Off the Appliance When Not In Use
If you do not intend to use the appliance for a longer period, set
the thermostat knob to the STOP (0) position, disconnect the
power supply, take out the foods and defrost and clean the
appliance. Leave the door slightly open.
Trouble-Shooting Guide
During the service, you can come across some troubles that in
most cases result from improper handling of the appliance and
can easy be eliminated.
The Appliance Fails to Operate After connecting to the
Mains Supply
Check the supply in the outlet socket and make sure the
appliance is switched on (thermostat in operating position).
Continuous Operation of the Refrigerating System
The door was frequently opened or it was left opened for too
long.
The door is not properly closed (the door may sag, the
gasket may be polluted or damaged).
Perhaps you have overloaded the appliance with fresh
foods.
The reason may be inadequate ventilation of the compressor
and condenser (assure adequate air circulation and wipe off
the condenser).
Continuous operation button activated (see section Freezing
of Food).
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the channel and through
the opening to the drain pan on the compressor, automatic
defrosting of the appliance is assured.
In case the ice formation on the inner back wall is increased (3-
5 mm), ice should be manually defrosted.
Set the thermostat knob to STOP (0) position and leave the
door open. Never use electric devices for defrosting and do not
scrape the ice or frost layer with sharp objects.
After completed defrosting, turn the knob to desired position
and close the refrigerator door.
The cause of increased ice formation may be one of the
following:
the door does not seal well (clean the gasket if it is
contaminated, or replace it if it is damaged);
the door was frequently opened or it was left opened for
too long;
the food stored in the refrigerator was warm;
the food or dish is touching the inner back wall.
Water is Leaking From the Refrigerator
In case the discharge water outlet is clogged, or the defrost
water drips over the channel, water leaks from the refrigerator.
Clean the clogged opening, for example with a plastic straw.
Manually defrost the increased ice layer. See "Ice Formation
on the Inner Back Wall".
The Freezer Door is Hard to Open
If you want to open the door that has just or recently been
closed, you may find it hard to open. The reason why this
happens is, that when you open the door, warm air gets into
the appliance and when it is getting cool, the underpressure
seals the door. After few minutes (5-10), the door can easily be
opened.
Noise
Cooling in refrigerating-freezing appliances is enabled by the
refrigerating system with compressor, which produces noise.
How noisy the appliance is depends on where it is placed, how
it is used and how old the appliance is.
During the operation of the compressor the noise of liquid
is heard and when the compressor is not operating, the
refrigerant flow is heard. This is a normal condition and it
has no influence whatsoever on the lifetime of the appliance.
After starting the appliance, the operation of the
compressor and the refrigerant flow may be louder, which
does not mean that something is wrong with the appliance
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gorenje rfg 325 w bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gorenje rfg 325 w in de taal/talen: Engels als bijlage per email.

De handleiding is 0,34 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info