479877
6
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
11.0 - VEHICLE CODE PROGRAMMING
In presence of a CAN-BUS line, the alarm needs a configuration depending on the vehicles model and
make.
The alarm is supplied without any programming, since Gemini does not know the vehicle on which the
module will be installed.
For this reason, programming has to be carried out during installation.
Indeed, even in the same vehicle's brand, operating differences are possible, according to the model
(es. Coupè o station wagon).
The vehicle's codes are given in the supplementary leaflet included in the alarm
packaging (the codes are updated at the packaging time).
Please refer to our web site “www.gemini-alarm.com” for updating information
(private area).
To program the vehicle code, proceed as follows.
When installation is complete, connect the 20-way wiring harness connector to the 20-way
system connector.
Push and hold the button located on the front of the alarm control unit until the LED is switches on.
Release the button the LED will switch off.
After a short pause, the LED will start flashing.
Count the number of LED flashes until it correspondes to the first number of the code, then press
the button on the front of the control unit.
After a short pause, the led will start flashing again.
Count the number of LED flashes until it correspondes to the second number of the code, then
press the button on the front of the control unit.
After a short pause, the led will start flashing again.
Count the number of LED flashes until it correspondes to the third number of the code, then press
the button on the front of the control unit.
At the end of programming procedure, the alarm will «repeat» the entered code, by flashing the
LED.
Verify the alarm system operation using the original radio control lock button of the vehicle.
If the entered code is correct and correspondes to the vehicle, the alarm will operate correctly.
If the code has been entered incorrectly repeat the procedure.
The table below refers the values corresponding to the LED flashes that have been entered in the
alarm.
!
!
!
!
!
!
!
!
!
!
!
!
!
.
FLASHFLASH
Sixth flash
Seventh flash
Eighth flash
Ninth flash
Tenth flash
First flash
Second flash
Third flash
Fourth flash
Fifth flash
VALUEVALUE
Number value-6-
Number value-7-
Number value-8-
Number value-9-
Number value-0-
Number value-1-
Number value-2-
Number value-3-
Number value-4-
Number value-5-
12.0 - E
“FIAT XXXXX”.
XAMPLE OF ALARM MODULE CODE PROGRAMMING
For better understanding of coding,described below the procedure for entering the vehicle code.
In the given example, the code 1-0-3 corresponds hypothetically to the car
Connect the 20-way wiring harness connector to the 20-way system connector.
.Push and hold the button shown in figure, until the LED is switches on
Release the button the LED switches off.
After 3/4 second pause the LED will start with the first sequence of flashes.
Push the button at firts LED flashing, corresponding to value “1”.
Push
Push
Push
FIRST FLASH
3/4 seconds
After 3/4 second pause the LED will start with the second sequence of flashes.
Push the button at tenth LED flashing, corresponding to value “0”.
After 3/4 second pause the LED will start with the third sequence of flashes.
Push the button at third LED flashing, corresponding to value “3”.
When the last digit has been entered, the alarm will “repeat” the entered code.
Press the vehicle radio control lock/unlock buttons to verify the alarm operation.
Eventually disconnect the 20-ways connector and reconnect it after few seconds.
TENTH FLASH
THIRD FLASH
ONE FLASH AND
SHORT PAUSE
TEN FLASHES AND
SHORT PAUSE
THREE FLASHES
AND SHORT PAUSE
!
PAGE 10 PAGE 11
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gemini 7832 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gemini 7832 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,6 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info