BEFORE FIRST USE
Unpack the appliance carefully and remove any promotional material attached to the kettle, but
do not remove the warning or model labels on the appliance. Before first use, fill the kettle to its
maximum level (1700/MAX), boil and discard the water.
CAUTION: The lid opens automatically just by pressing the opening button. Ensure that there are
no objects in the interior of the kettle. Do not immerse the kettle base, switch area, power base
or power cord in water, or allow moisture to come in contact with these parts.
1. To fill the kettle, remove it from the power base and open the lid by pressing the opening
button.
2.
Fill in pure tap water (drinking quality) up to the water level mark 1700/Max. Try to hold the
kettle as level as possible, while doing so.
Boil the water as described in the following section (Operating Your Design Kettle).
3.
Discard the water.
NOTE: Your kettle will only operate when positioned on the power base with the power switch
in the ‘On’ position (red). The kettle will automatically switch OFF, once the water has boiled.
Too little water will result in the kettle switching OFF before the water has boiled.
OPERATING YOUR DESIGN KETTLE ADVANCED
CAUTION! Only fill with pure drinking water. Do not fill any other liquids or foodstuffs into the
water container and do not add any additional ingredients, such as spices or flavours. Do not
place any foreign objects in the water container. Do not drip or spill any liquids on the exterior
of the kettle or on the power base.
Ensure the kettle is filled with the appropriate amount of water (water level between 500 and
1700/MAX) before switching on the appliance.
WARNING! Do not use any extension cord or multi socket outlet to avoid risk of fire and
electric shock. Always connect the appliance directly to a separately protected mains power
supply wall socket with protective conductor (earth/ground) connected properly (see Important
Safeguards for Electrical Appliances). Always completely unwind the power cord before connec-
ting the plug to the power supply.
Do not use any mains adapter other than the supplied power base for the kettle.
Always place the appliance on a stable, level, dry and sufficiently large surface. Ensure, that the
power base will not tilt or wobble during operation. Do not operate the appliance on an inclined
surface, to avoid scalding and damage by boiling water overflowing the brim of the kettle.
Beware of hot surfaces! The exterior of the kettle and lid will get very hot during operation.
Only use handles and knobs for handling the appliance. Beware of hot condensate and steam,
when opening the lid.
Immediately switch OFF and unplug the appliance, if water leaks out of the kettle.
1.
Prepare the power base for use. Completely unwind the power cord from the cord storage and
insert it in the gab on the bottom of the power base.
Place the power base on an appropriate surface (level, dry, water-resistant and heat-resistant).
During operation, always keep the appliance away from other objects: leave at least 20 cm of
19
