665016
3
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
VHF 100/200 Series Radio Installation Instructions 3
Flush Mounting the VHF 100/200 Series Radio
In addition to the four included 4.2 × 25 mm, panhead mounting screws, ush mounting the VHF 100/200 series radio requires the
following tools (not included):
Phillips screwdriver
Drill and 9/64 in. (3.5 mm) drill bit for mounting holes
3/8 in. (10 mm) drill bit for a starter hole
Jigsaw
Scissors and tape
Center punch and hammer
File and sandpaper
Anti-seize lubricant (optional)
NOTE: Ensure that the surface on which you mount the VHF 100/200 series radio has sufcient open space behind it to accommodate the radio
and the connected cables. There should be at least 5 in. (127 mm) of clearance behind the case.
To ush mount the VHF 100/200 series radio:
1. Cutandtrimtheush-mounttemplate(page 9)andensureitwilltinthelocationwhereyouwanttoushmounttheVHF100/200
series radio.
2. Tapetheush-mounttemplatetothemountinglocation.
3. Use the center punch to indent the center of each of the four mounting-hole locations.
4. Use a 9/64 in. (3.5 mm) drill bit to drill the four mounting holes.
5. Use a 3/8 in. (10 mm) drill bit to drill a starter hole inside the corner of the template to
begin cutting the mounting surface.
6. Use the jigsaw to cut the mounting surface along the inside of the dashed line indicated
onthetemplate.Usealeandsandpapertorenethesizeofthehole.
7. Placetheradiointothecutouttoconrmthatthefourmountingholesarecorrectafter
reningthehole.Ifnot,markthecorrectlocationsofthefourmountingholes.Removethe
radio from the cutout.
8. Apply the gasket to the back of the VHF 100/200 series radio.
9. IfthetopandbottomsnapcoversareattachedtothefrontoftheVHF100/200seriesradio,removethem
by unsnapping the covers from the sides.
10. Place the VHF 100/200 series radio into the cutout.
11. Securely tighten the four mounting screws through the VHF 100/200 series radio into the drilled mounting holes.
Snap covers
NOTE: Stainless-steel screws may bind when screwed into berglass and overtightened. Garmin recommends applying an anti-galling, stainless,
anti-seize lubricant to the screw before using.
12. Place the snap covers over the mounting screws.
Gasket
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin VHF 110i bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin VHF 110i in de taal/talen: Engels als bijlage per email.

De handleiding is 1,9 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin VHF 110i

Garmin VHF 110i Installatiehandleiding - Nederlands - 10 pagina's

Garmin VHF 110i Gebruiksaanwijzing - Nederlands - 60 pagina's

Garmin VHF 110i Installatiehandleiding - Deutsch - 10 pagina's

Garmin VHF 110i Gebruiksaanwijzing - Deutsch - 60 pagina's

Garmin VHF 110i Gebruiksaanwijzing - English - 60 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info