501971
2
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
2 GPSMAP 700 Series Installation Instructions
Bail Mounting the Chartplotter
Use the included bracket to bail mount the GPSMAP 700 series chartplotter. You can route cables from under the mounting surface through the
included bail-mount bracket, though it is not necessary. See page 3 for instructions on installing the bail-mount bracket without routing cables
through the bracket.
Hardware (included):
Bail-mount bracket
Cable-organization bracket
Bail-mount template
Four 35 mm M 4.2 × 1.4 screws (to secure the bail-mount bracket )
Two 20 mm M 3.5 × 1.3 screws (to secure the cable-organization
bracket)
Tools required (not included):
Jigsaw
Drill and drill bits—1
1
/
4
in. (32 mm), and
1
/
8
in. (3 mm)
Number 2 Phillips screwdriver
To install the bail-mount bracket with the cables routed through the bracket:
1. Using the included bail-mount bracket template, determine the best place to install the bracket. Be sure to leave adequate clearance behind
the chartplotter for the wiring.
NOTE: To avoid interference, mount the GPSMAP 700 series chartplotter at least 32 in. (813 mm) from a magnetic compass.
2. The bail-mount bracket template has adhesive on the back. Remove the
protective liner and apply the template to the location at which you want to install
the bail-mount bracket.
3. Use a 1
1
/
4
in. (32 mm) drill bit to drill the pass-through hole in the center of the
template.
4. Use a use a
1
/
8
in. (3 mm) drill bit to drill the six pilot holes marked on the bail-
mount template.
NOTE: If you are mounting the chartplotter in berglass, it is recommended to use
a countersink bit to drill a clearance-counter bore through only the top gel-coat
layer. This will help to avoid any cracking in the gel-coat layer when the screws
are tightened.
5. Remove the bail-mount bracket template from the mounting surface.
6. Route the cables pertinent to your installation through the hole you drilled in step 3,
from under the mounting surface.
If you plan to use all four cables, route them in the following order to ensure that
they will all t correctly:
Radar cable
Power/data wiring cable
GA 30 GPS antenna cable
NMEA 2000 cable
NOTE: Do not install the locking ring (page 4) on the power/data or radar cable until after you route it through the mounting surface.
7. Place the cable-organization bracket around the cables and into the 1
1
/
4
in. (32 mm) hole you drilled in step 3.
8. Use the two included 20 mm M 3.5 × 1.3 screws to secure the cable-organization bracket to the mounting surface.
NOTE: Stainless-steel screws may bind when screwed into berglass and
overtightened. Garmin recommends applying an anti-galling, stainless anti-seize
lubricant to the screw before using.
9. Extend 6–7 in. (152–178 mm) of cable slack through the cable organization bracket, and
secure each cable to the correct clips. Refer to the cable-organization bracket diagram
for the clip assignments.
10. Place the bail-mount bracket over the cable-organization bracket and route the cables
through the back of the bail-mount bracket.
11. Secure the bail mount to the surface using the four included 35 mm M 4.2 × 1.4 screws.
12. Follow the steps on page 3 to install the GPSMAP 700 series chartplotter on the bail
mount bracket. Test the slack-length of the cables routed through the bracket.
13. Make cable slack-length adjustments if necessary. Apply marine sealant (optional).
Cable-organization
bracket
Bail-mount
bracket
GPSMAP
700 series
chartplotter
Bail-Mounting the GPSMAP 700 Series Chartplotter
Cable-organization
bracket
Bail-mount
bracket
GPSMAP
700 series
chartplotter
Bail-Mounting the GPSMAP 700 Series Chartplotter
Cable-Organization-Bracket Clip Identication
GA 30 GPS antenna cable clip
Power/data cable clip
Garmin Marine Radar cable clip
NMEA 2000 cable clip
Cable-Organization-Bracket Clip Identication
GA 30 GPS antenna cable clip
Power/data cable clip
Garmin Marine Radar cable clip
NMEA 2000 cable clip
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin GPSMAP 721 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin GPSMAP 721 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin GPSMAP 721

Garmin GPSMAP 721 Installatiehandleiding - Nederlands - 8 pagina's

Garmin GPSMAP 721 Gebruiksaanwijzing - Nederlands - 100 pagina's

Garmin GPSMAP 721 Installatiehandleiding - Deutsch - 10 pagina's

Garmin GPSMAP 721 Gebruiksaanwijzing - Deutsch - 104 pagina's

Garmin GPSMAP 721 Gebruiksaanwijzing - English - 100 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info