740401
4
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
An antenna-selection prompt appears on the connected
chartplotters.
NOTE: If the entire system is being turned on for the first
time, the antenna-selection screen is part of the initial setup
process.
2
Select the installed antenna size for each open-array radar
installed on the boat.
TIP: If you need to specify a different antenna size, while
viewing the radar screen for the radar you want to change ,
select Menu > Radar Setup > Installation > Antenna
Configuration > Antenna Size, and select the antenna size.
Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of
the radar scanner on a boat, if the radar scanner does not align
with the bow-stern axis.
Measuring the Potential Front-of-Boat Offset
The front-of-boat offset compensates for the physical location of
the radar scanner on a boat, if the radar scanner does not align
with the bow-stern axis.
1
Using a magnetic compass, take an optical bearing of a
stationary target located within viewable range.
2
Measure the target bearing on the radar.
3
If the bearing deviation is more than +/- 1°, set the front-of-
boat offset.
Setting the Front-of-Boat Offset
Before you can set the front-of-boat offset, you must measure
the potential front-of-boat offset.
The front-of-boat offset setting configured for use in one radar
mode is applied to every other radar mode and to the Radar
overlay.
1
From a Radar screen or the Radar overlay, select Menu >
Radar Setup > Installation > Front of Boat.
2
Select Up or Down to adjust the offset.
Setting a Custom Park Position
If you have more than one radar on your boat, you must be
viewing the radar screen for the radar you want to adjust.
By default, the antenna is stopped perpendicular to the pedestal
when it is not spinning. You can adjust this position.
1
From the radar screen, select Menu > Radar Setup >
Installation > Antenna Configuration > Park Position.
2
Use the slider bar to adjust the position of the antenna when
stopped, and select Back.
Specifications
Dimensions
Item Measurement Description
À
185.9 mm (7
5
/
16
in.) Center of rotation to the rear of the pedestal
Á
234.7 mm (9
1
/
4
in.) Center of rotation to the front of the pedestal
Â
86 mm (3
25
/
64
in.) Center of rotation to the rear mounting holes
Ã
114 mm (4
1
/
2
in.) Center of rotation to the front mounting
holes
Ä
200 mm (7
7
/
8
in.) Distance between the mounting holes
Item Measurement Description
À
4 ft. models: 132.8 cm (4 ft.
4
5
/
16
in.)
6 ft. models: 193.8 cm (6 ft.
4
5
/
16
in.)
Antenna length
Á
40.3 cm (15
7
/
8
in.) Base of the pedestal to the top of
the antenna
Â
28.6 cm (11
1
/
4
in.) Width of the pedestal at the base
Ã
36.4 cm (14
5
/
16
in.) Width of the pedestal in the center
Physical Specifications
Specification Measurement
Minimum safe
operating distance*
4 ft. antenna
100 W/m
2
: 1.35 m (53.2 in.)
50 W/m
2
: 1.90 m (74.8 in.)
10 W/m
2
: 4.25 m (167.3 in.)
6 ft. antenna
100 W/m
2
: 1.70 m (66.9 in.)
50 W/m
2
: 2.40 m (94.5 in.)
10 W/m
2
: 5.35 m (210.6 in.)
Compass-safe distance 305 mm (12 in.)
Pedestal weight 15.7 kg (34.7 lb.)
Antenna weight 4 ft. antenna: 5.2 kg (11.4 lb.)
6 ft. antenna: 7.3 kg (16.0 lb.)
Power cable length 15 m (49 ft. 3 in.)
Network cable length 15 m (49 ft. 3 in.)
Antenna rotation speed 24 rpm and 48 rpm
NOTE: The antenna can rotate at 48 rpm only
when in single range mode, with
MotionScope
disabled, and for range settings
of 12 nm or lower.
Maximum wind load 80 kn
Temperature range From -15 to 55ºC (from 5 to 131ºF)
Humidity 95% at 35°C (95°F)
Water resistance IEC 60529 IPX6 (protected against heavy
seas)
Bearing accuracy 0.25 degrees
Important:
*The specified 100 W/m
2
minimum distance must to be
maintained between the antenna and the occupational user
and the specified 10 W/m
2
must be maintained between the
antenna and the general public. Under such configuration, the
radio frequency radiation exposure limits set forth for a
population/uncontrolled environment are satisfied.
Electrical Specifications
Specification Measurement
Input voltage From 10 to 32 Vdc
Fuse 15 A, blade-type
Input power Typical: 55 W
Maximum: 160 W
4
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin GMR Fantom 6 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin GMR Fantom 6 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin GMR Fantom 6

Garmin GMR Fantom 6 Installatiehandleiding - Nederlands - 6 pagina's

Garmin GMR Fantom 6 Installatiehandleiding - Deutsch - 6 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info