691892
2
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
GC
100
Installation Instructions
Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Mounting Considerations
You must mount the camera in a location where it is not
submerged.
You should mount the camera within 76 m (250 ft.) of a
chartplotter. The range depends on your installation location
and obstacles between the camera and the chartplotter. If the
camera is out of range of the chartplotter due to obstacles or
distance, you must reposition the camera.
You should test the camera in your desired location before
you permanently mount the camera.
You should mount the camera so that the cable can be
connected easily.
You should mount the camera in a location where it cannot
be damaged by docks, pilings, or other pieces of equipment.
You should mount the camera so it does not present a
hazard in doorways or walkways.
You should mount the camera in a location where you can
remove the camera.
Mounting the Camera
1
Using a 3.2 mm (
1
/
8
in.) drill bit, drill a pilot hole.
NOTE: If you are mounting the camera onto fiberglass, it is
recommended to use a countersink bit to drill a clearance
counterbore through the top gelcoat layer only, but no
deeper. This will help to avoid cracking the gelcoat layer
when the screws are tightened.
2
Using the included screw, fasten the camera mount to the
mounting surface.
3
Insert the camera
À
into the housing
Á
.
4
Close the front of the housing.
5
Tighten the tamper-proof side screws using the included tool.
6
Connect the power cable.
Pairing the GC
100 Camera with a Garmin
®
Chartplotter
Before you can connect a wireless device to the chartplotter
wireless network, you must configure the chartplotter wireless
network.
1
With the camera within an unobstructed 76 m (250 ft.) of the
chartplotter, quickly press three times.
2
On the chartplotter, select Settings > Communications >
Wireless Devices > Garmin Camera > Start.
3
Follow the on-screen instructions.
Turning the Camera Off
Hold for 3 seconds.
NOTE: If you hold for more than 10 seconds, the camera
resets.
Specifications
Water rating* IEC 60529 IPX6/IPX7
Operating temperature range From -20 to 60°C (from -4 to 140°F)
Charging temperature range From 0 to 45°C (from 32 to 113°F)
Storage temperature range From -40 to 85°C (from -40 to 185°F)
Input voltage From 3.9 V to 6.2 V, 2 A
Compass-safe distance 10 cm (4 in.)
Wireless frequency and protocol 2.4 GHz WiFi
®
@ 17 dBm nominal
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to www.garmin.com
/waterrating.
GC 100 Blink Codes
After the camera is installed and paired with the chartplotter, the
camera turns on when the chartplotter is turned on. The color
and blink sequence of the status LED on the camera indicates
its operational status.
LED
Color
LED State Status
Green Three blinks The camera is turning on.
Red Three blinks The camera is turning off.
Blue One blink per second for up to
two minutes, or until the
camera connects to a
chartplotter
The camera is attempting to
connect to a chartplotter
using WiFi.
Amber One blink per second until the
camera powers down or the
battery is charged
The camera battery is not
charged sufficiently to
stream video.
2 Installation Instructions
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin GC 100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin GC 100 in de taal/talen: Duits, Engels, Frans, Italiaans, Spaans, Deens, Zweeds, Noors als bijlage per email.

De handleiding is 0,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info