699110
3
Verklein
Vergroot
Pagina terug
1/34
Pagina verder
If you do not see video on the Garmin device at the preferred
installation location, move the transmitter to another location
and test it again.
4
Repeat steps 2–3 until the transmitter operates correctly.
5
Test the camera view by observing the video on the device.
6
If the camera does not provide the optimal view for your
vehicle, move it to another location and test it again.
7
Repeat steps 5–6 until the camera mounting location
provides the optimal view for your vehicle.
TIP: Make note of the camera orientation when you are
testing the camera view to ensure correct permanent
installation.
Mounting the Camera
Before you permanently mount the camera, you should test the
mounting location for the optimal view for your vehicle (Testing
the Camera and Transmitter Location, page 2).
If you have already connected the camera to the bracket, you
must first disassemble it.
1
Place the bracket
À
in the mounting location.
2
Select an option:
If you are mounting the bracket directly on the surface of
your vehicle, mark the locations of the two holes on the
bracket
Á
.
If you are installing the bracket on a license plate, remove
one of the license plate screws and clip the bracket onto
the license plate, aligning the hole on the bracket
Â
with
the hole on the license plate.
3
Secure the bracket to the vehicle using either the included
self-tapping screws
Ã
or the license-plate screw you
removed in step 2
Ä
.
4
Place the camera in the bracket, and determine the best
place for the camera cable
Å
to enter the vehicle.
5
Using an appropriate drill bit, drill a hole for the camera cable
to enter the vehicle.
6
Feed the camera cable through the hole and route it to the
transmitter location.
7
Secure the camera in the bracket using the included hex
bolts
Æ
.
8
Adjust the angle of the camera and tighten the hex bolts
using the included hex key.
9
Apply RV sealant around the cable where it enters the
vehicle (optional).
Installing the Transmitter
Before you permanently install the transmitter, you must test the
installation location for correct operation (Testing the Camera
and Transmitter Location, page 2).
1
Secure the transmitter to the installation location using
hardware appropriate for the location, such as screws, bolts,
or cable ties.
The fuse holder located near the transmitter is not
waterproof. Installing the fuse holder in a location that is
exposed to the elements is not recommended.
2
Connect the camera and transmitter cables.
The connector between the camera and the transmitter is not
waterproof. If you make this connection in a location exposed
to the elements, you must make sure that the connection is
waterproof.
3
Connect the power cable
À
from the transmitter to a 12–
24 VDC power source, preferably a reverse lamp
Á
, using a
solderless wire-splice connector (not included).
NOTE: Connecting the transmitter to an always-on
12-24 VDC source (such as a running lamp) instead of a
reverse lamp requires you to manually switch power to the
transmitter. The transmitter may drain your vehicle battery if it
is left on.
4
If you did not use a solderless wire-splice connector, solder
and heat-shrink the electrical connections to protect them
from the elements.
Pairing the Camera with a Garmin Navigation
Device
1
Turn on the compatible Garmin navigation device, and bring
it within 3 m (10 ft.) of the camera.
2
Select Apps > Rear View.
3
Select Add New Camera.
4
Follow the on-screen instructions.
Multiple Cameras
You can pair up to 4 wireless cameras with a compatible Garmin
device. For example, you can pair one backup camera installed
on the cab and a second backup camera installed on a trailer.
See the BC
35 Owner's Manual for information about pairing
multiple cameras.
Appendix
Getting the Owner's Manual
You can get the most recent owner's manual from the web.
1
Go to garmin.com/manuals/BC35.
2
View or download the full owner's manual in your preferred
format.
Specifications
Camera and transmitter input
voltage
From 9 to 28 Vdc
Transmitter fuse 500 mA, fast-blow
Camera and transmitter current
usage
150 mA at 12 Vdc
Water rating (camera) IEC 60529 IPX7*
Installation Instructions 3
3

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Garmin-BC35

Zoeken resetten

  • Ik krijg de camera niet gekoppeld aan Garmin 780 terwijl beide wel op dezelfde WiFi zitten. Ook lijkt de camera er dood, geel led oid bij aangesloten zijn op voeding ?? Gesteld op 13-6-2023 om 17:41

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Garmin BC35 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Garmin BC35 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 1,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Garmin BC35

Garmin BC35 Gebruiksaanwijzing - Nederlands - 8 pagina's

Garmin BC35 Gebruiksaanwijzing - Deutsch - 8 pagina's

Garmin BC35 Gebruiksaanwijzing - English - 8 pagina's

Garmin BC35 Gebruiksaanwijzing - Français - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info