699093
5
Verklein
Vergroot
Pagina terug
1/56
Pagina verder
5
until earth voltage is 200 volts
or below.
Find a location for your earth
system that is permanently damp,
has high fertility or salinity and
is away from dairy sheds. Install
the earth system at least 10m (33ft)
from any power supply earth peg,
underground telephone or power cable.
The best construction is 2m (6
1
/
2
ft) long
galvanised stakes G8790 or Super Earth
Kits G8800, 3m (10ft)
apart, connected to
the Energizer by high
quality Lead-out cable
G6270. Do not use
materials that rust.
(Use G6272 if the
earth system is over
100m (300ft) from the
Energizer).
Step 1
Mount the Energizer
a) For inside use only. Mount the Energizer on a wall, out of reach of children, adjacent to
a power outlet. Install where there is no risk of the Energizer incurring fi re or mechanical
damage (illustration a).
b) Using the template on centre pages, drill 3 holes (A,B & C).
Use a 4mm (5/32”) diameter drill for timber walls or a suitable wall plug for brick and
concrete walls (illustration b).
c) Fix the screws provided into the wall, leaving the head of the screw about 3mm (1/8”) out
from the wall (illustration c).
d) Position the Energizer over the mounting screws and slide down until it is fi rmly in place.
Step 2
Connect to Earth (Ground) System
Using Lead-out Cable G6270 remove 5cm (2”) of plastic coating from one end of the cable
and attach to the green terminal on the Energizer. Attach the cable to the earth system by
removing 10cm (4”) of insulation from the cable at each Earth Stake, then clamp the exposed
wire to each stake using an Earth Clamp G8760. Tighten the clamp.
For further instructions on the earth (ground) system see “How to install earth (ground)
system” section.
Step 3
Connect the Fence
Connect Energizer’s red terminal to the fence using Lead-out Cable G6270: remove 5cm (2”)
of plastic coating from one end of the cable and attach to the red terminal on the Energizer.
Attach the other end of the cable to the fence using a Joint Clamp G6030. For instructions on
fence installation see “How to install the fence” section.
Step 4
Plug the Energizer into a power outlet
Indicator lights give you information about the Energizer and fence.
4 step installation guide
Earthing (Grounding)
Earthing the Energizer is the
key for a successful Power
Fence. Poor earthing
is the most common
reason for poor electric
fence performance. Check
the voltage on your earth system
using a Digital Volt Meter G5030.
Keep adding Earth Stakes G8790
a
b
c
G8760
G8790
Handy
hint
GREEN
RED
To Fence
To Earth System
Power/Standby Light: MR2500 Power/Standby Light: MR5000
Constant Green
Constant Yellow
Flashing Red
Constant Red
- Energizer OK, Full Power
- Energizer OK, Low Power
- Remote Control Interference
- Standby
Flashing Green
Constant Green
Constant Yellow
Flashing Red
Constant Red
- Energizer OK, Turbo Power
- Energizer OK, Full Power
- Energizer OK, Low Power
- Remote Control Interference
- Standby
Fence Light: Fence Light:
Flashes Green with each fence pulse over approx. 3.4kV
Flashes Red with each fence pulse below approx. 3.4kV
Flashes Green with each fence pulse over approx. 1.0kV
Flashes Red with each fence pulse below approx. 1.0kV
English
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Gallagher MR2500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Gallagher MR2500 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Deens, Zweeds als bijlage per email.

De handleiding is 0,88 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info