9
6.1 Technical data
Pay attention to the "Important notes" (Chapter 1).
The appliance must only be installed by an
authorised specialist, paying attention to the
relevant regulations of the power supply companies
and the regional construction regulations.
The installing technician is responsible for
perfect functioning of the appliance at its
installation location. The operation principle must
be explained to the user with reference to the
operating instructions. He must draw the user's
attention as to how to isolate the appliance from
the mains whenever necessary.
This cooker corresponds to heat class Y and must
be installed in a cabinet as detailed in the sketch
(Fig. 8).
When establishing the electrical connections,
make sure that connecting leads cannot come into
contact with hot parts of the cooking surface.
Protection against shock hazards must be ensured
after installation!
Pay attention to the data on the rating plate and
connect the PE conductor. Connect the connecting
cable to the mains. The appliance can be
connected with an earthing-pin plug or it can be
connected permanently.
Shock hazard protection from below must be
ensured after installation, e.g. by the installation of
an intermediate shelf that can only be removed
using tools.
If all poles of the appliances cannot be isolated
from the mains by removing an accessible plug (of
a permanent connecting lead), an isolating device
with a contact gap of at least 3 mm must be
installed (e.g. domestic fuse).
Damages caused by failure to observe these
installation instructions cannot be recognised.
There should be a distance of at least 20 mm
between the edge of the appliance and
combustible walls or furniture items.
The distance between the intermediate shelf and
the worktop in which the range is recessed must be
at least 70 mm.
There should be a distance of at least 20 mm from
the bottom edge of the housing trough and the next
combustible item of furniture.
If installed at an offset above a base cupboard or
if several appliances from the Vario series are
installed adjacently, the housing can lie on the side
walls of the cupboard.
Note: please note that a distance of 10 mm from
the cupboard side walls must be observed for
safety reasons.
This appliance may be installed in kitchen
combinations made of wood or similar combustible
materials without taking additional measures.
Note: do not stick the cooking surface onto the
worktop with silicone!
6. Assembly instructions
