522135
30
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
24
4. INSTALLATION
4.1 Display Unit
Mounting considerations
The display unit can be installed on a
desktop, on the bulkhead or flush
mounted in a panel. When choosing a
location keep the following in mind:
Keep the display unit out of direct
sunlight.
The temperature and humidity should
be moderate and stable.
Locate the unit away from exhaust
pipes and vents.
The mounting location should be well
ventilated.
Mount the unit where shock and
vibration are minimal.
For maintenance and checking
purposes, leave sufficient space at
the sides and rear of the unit and
leave slack in cables.
A magnetic compass will be affected if
the display unit is placed too close to
it. Observe the following compass
safe distances to prevent disturbance
to the magnetic compass:
Standard compass: 0.4 meters
Steering compass: 0.3 meters
Desktop, overhead mounting
1. Fix the bracket to a desktop or the
overhead with tapping screws
(supplied).
2. Loosely screw knobs into the display
unit.
3. Set the display unit to the bracket
and then tighten the knobs.
Mounting on the bulkhead, Flush
mounting in a panel
See the instructions on the bulkhead or
flush mounting template (supplied).
4.2 Thru-hull Mount
Transducer
Transducer mounting location
The thru-hull mount transducer
(520-5PSD, 520-5MSD) provides the
best performance of all, since the
transducer protrudes from the hull and
the effect of air bubbles and turbulence
near the hull skin is reduced. When the
boat has a keel, the transducer should
be at least 30 cm away from it. Typical
thru-hull mountings are shown in the
figure on the next page.
The performance of this sounder is
directly related to the mounting location
of the transducer, especially for
high-speed cruising. The installation
should be planned in advance, keeping
the standard cable length (8 m) and the
following factors in mind:
Air bubbles and turbulence caused by
movement of the boat seriously
degrade the sounding capability of the
transducer. The transducer should,
therefore, be located in a position
where water flow is the smoothest.
Noise from the propellers also
adversely affects performance and
the transducer should not be mounted
nearby. The lifting strakes are
notorious for creating acoustic noise,
and these must be avoided by
keeping the transducer inboard of
them.
The transducer must always remain
30

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Furuno LS-4100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Furuno LS-4100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,34 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info