DAYTIME RUNNING LAMPS
WARNING
Always remember to switch your
headlamps on in low light situations
or during inclement weather. The
system does not activate the tail lamps
and may not provide adequate lighting
during these conditions. Failure to activate
your headlamps under these conditions
may result in a collision.
To switch the system on:
1. Switch the ignition on.
2. Switch the lighting control to the off or
autolamp position.
AUTOMATIC HIGH BEAM
CONTROL
WARNINGS
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the high beam on or off.
A manual override may be required
when approaching other road users
such as cyclists.
Do not use the system in fog.
In cold and severe weather
conditions the system may not
function. A manual override may be
necessary in these cases.
The system may not deactivate the
high beam if the lights of oncoming
vehicles are hidden by obstacles (for
example guard rails).
WARNINGS
Check and replace wiper blades
regularly to ensure the camera
sensor has a clear view through the
windscreen. Replacement wiper blades
must be the correct length.
Note: Keep the windscreen free from
obstructions such as bird droppings, insects
and snow or ice.
Note: Reflective road signs may be
detected as oncoming traffic and the
headlamps will be switched to low beam.
Note: Always fit Ford Original Parts when
replacing headlamp bulbs. Other bulbs may
reduce system performance.
The system will automatically switch on
high beams if it is dark enough and no other
traffic is present. If it detects an
approaching vehicle’s headlamps or tail
lamps, or street lighting ahead the system
will switch off high beam before it can
distract other road users. Low beam will
remain on.
A camera sensor is centrally mounted
behind the windshield of your vehicle. This
monitors conditions continuously to decide
when to switch the high beams on and off.
Once the system is active the high beam
will switch on if:
• It is dark enough to require the use of
high beams and
• there is no traffic or street lighting
ahead and
• vehicle speed is greater than 25 mph
(40 km/h).
The high beam will switch off if:
• The rear fog lamps are switched on.
• The ambient light is high enough that
high beam is not required.
• An approaching vehicle's headlamps
or tail lamps are detected.
62
C-MAX (CEU) Vehicles Built From: 16-03-2015 Vehicles Built Up To: 19-07-2015, CG3642en enGBR, Edition date: 02/2015, First Printing
Lighting
