795134
3
Verklein
Vergroot
Pagina terug
1/5
Pagina verder
34
InItIAl SetuP
EMERGENCY OVERRIDE KEY USE
Insert emergency override key into
the lock, turn it counterclockwise
and pull the door open.
BATTERY INSTALL
1 Remove battery cover.
2 Install four (4) AA batteries. Make sure to
install them facing the proper direction.
3 Replace the battery cover.
4 When installed correctly, a yellow light
will ash on the digital keypad.
ProgrAmmIng A PerSonAl PASScode
1 Open the safe door.
2 Press the reset button located on the left side of the
battery compartment. (The lock will beep two times
and the yellow light will blink two times).
3 Enter your new three to eight (3-8) digit passcode
followed by ‘A’ or ‘B. (The lock will beep two times and
the yellow light will blink two times).
NOTE: After pressing the reset button, your passcode must
be programmed within 10 seconds, or it will not be accepted.
LOCKOUT PENALTY:
Green light means correct passcode has been entered. Rapid beeping yellow light
means incorrect passcode has been entered. Entering incorrect passcode three (3)
times will result in lock-out.
IF LOCK-OUT OCCURS:
1 Wait 15 minutes before entering your (3-8) digit passcode.
2 Check to see if the batteries have been installed properly and replace if
necessary.
3 Contact Consumer Aairs at 1-800-323-9005.
3
2
1
6
5
4
9
8
7
B
0
A
Initial Setup Shelf and Mounting
FORGOTTEN PASSCODE
1 Insert override key, turn counterclockwise and pull the door open.
2 Follow instructions on Pg. 3 ‘PROGRAMMING A PERSONAL PASSCODE’ to reset
your passcode.
OPENING SAFE
1 Insert knob key.
2 Enter your three to eight (3-8) digit passcode
followed by ‘A’ or ‘B.
3 Turn the key clockwise and pull the door open.
CLOSING SAFE
1 Push door closed.
2 Turn knob key counterclockwise fully into locked position.
ImPortAnt Turn the light switch o before closing the safe. Leaving the
light switch on will result in loss of battery power.
ShelF And mountIng
INSTALLING THE SHELF 2072F ONLY
Slide shelf into place on top of shelf racks.
MOUNTING INSTRUCTIONS
1 Remove rubber feet and mounting screws
from safe with Phillip’s head screwdriver.
2 Place your safe where you want it to be mounted. Safe weighs
(36.1 lbs - 2072F; 19.8 lbs. – 2073F; 13.2 lbs. – 2025F) when empty so
be sure that if you’re mounting on a shelf that it will support the weight.
3 Open your safe.
4 Remove the bottom carpet and nd the screw holes.
Mark the safe’s placement through the holes with a pencil.
5 Drill holes in the shelf.
6 Place screws through holes in shelf and rubber feet.
7 Place safe on shelf over the screws and rubber feet. Use a socket wrench
to tighten safe into place.
3
2
1
6
5
4
9
8
7
B
0
A
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
3
2
1
6
5
4
9
8
7
B
0
A
Beep
3
2
1
6
5
4
9
8
7
B
0
A
Beep
AA
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA
+-
AA +
AA
+-
AA
+-
AA
+-
AA
+-
3
2
1
6
5
4
9
8
7
B
0
A
3
2
1
6
5
4
9
8
7
B
0
A
1
2
3 4
AA +
AA
+-
AA
+-
AA
+-
AA
+-
15
6
7
4
4
1
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw First Alert 2025F bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van First Alert 2025F in de taal/talen: Engels als bijlage per email.

De handleiding is 3.07 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info