10 Ferm
SPARE PARTS LIST AAA-000
REF NR DESCRIPTION FERM NR
- CAPACITOR (8 µF) 311048
13 SPARE SAW BLADE (1.425 X 6 X 0,3 MM) 330795
16 RUBBER BAND 403461
19 PRESSED HANDLE (COMPLETE, PART 19, 20, 21, 22, 23, 24 + 25) 403463
36 MAGNETIC SWITCH 403469
50 MOTOR 403471
79 SAW GUIDE (COMPLETE, PART 79, 80, 81 + 82) 403483
105 INLAY TABLE 403486
112 OPERATING HANDLE (COMPLETE, PART 111 - 114) 403497
120 ANGLE GUIDE (COMPETE, PART 115 - 120) 403493
130 BASEMENT 403496
OPERATIONAL SAFETY
Warning! This machine can produce fine dust,
which is harmful to your health – always wear a sui-
table dust mask and other protection equipment as approp-
riate. Use dust extraction
Concentrate
Routine and repetition can lead to mistakes. Remember
that a slight lack of concentration can result in serious
injuries in a split second.
Keep work area clean
Cluttered areas and benches invite injuries
Consider the work environment
Do not expose power tools to rain or use them in damp
or wet locations. Keep work area well lit. Do not use
power tools in the presence of flammable liquids, vap-
ours or gases.
Guard against electric shock
This unit contains dangerous voltages. Use a RCD (resi-
dual current device) to provide protection against elec-
trical shock. Prevent body contact with grounded sur-
faces (e.g. pipes, radiator, ranges or refrigerators).
Keep children and pets away
Do not let children or pets come into contact with the
tool, extension cable or work area.
Do not force the tool
It will work better and safer at the rate for which it was
intended.
Use the right tool
Do not force small tools or attachments to do the job of a
heavy-duty tool. Do not use tools for purposes for which
they were not intended; for example do not use a circular
saw for cutting trees or logs.
Do not abuse cable
Never carry the tool by the cable or pull it to disconnect
it from the power socket. Keep the cable away from heat,
oil and sharp edges. Do not touch the metal plug pins
when connecting or removing the plug.
Do not over-reach
Keep a proper footing and balance at all times.
Disconnect tools from power supply
When not in use, before servicing and when changing
accessories such as blades, bits and cutters.
Always switch off and unplug the saw from the
power supply before making adjustments or chan-
ging blades .
Remove adjusting keys and wrenches
Ensure that they are removed from the tool before swit-
ching on.
Avoid unintentional starting
Do not carry plugged in tools with your finger on the
switch. Check that the switch is off before plugging in to
socket.
Connect a dust extraction device
Whenever there are facilities for fitting a dust of fume
extraction system, make sure it is connected and used.
Use recommended accessories
The use of any other accessory or attachment other than
recommended in the instructions or catalogue may pre-
sent a risk of personal injury. Use extension cables suita-
ble for the power input of the saw (minimum cable size
1.5mm
2
). When using a cable reel unwind the cable fully.
Ferm 3
