10
Using Your Floor Steamer
D. Relling Boiler During Use
WARNING:
Let Steamer cool 5 minutes before opening Boiler Cap.
Use care when opening the Boiler Cap – it may still be hot and steam
may escape, causing burns. If Boiler is still hot, water may spurt out
during relling – this can also cause burns.
• Unplug appliance.
• Press trigger on the Handle to clear steam from Steam Nozzles.
• Press down and slowly turn Boiler Cap counterclockwise. This will al-
low remaining steam to escape.
•
Be sure Steamer has cooled 5 minutes before relling with water.
• Fill Boiler using Measuring Cup provided. Be sure Steamer Handle
remains in the upright “Off” position. Fill only 0.6 litres. Do not overll
the Boiler as excess water will be ushed out of the Boiler before dry
steam will emit.
• Firmly push down and screw Boiler Cap back on by turning it
clockwise.
• Insert plug into 3-prong electrical outlet.
REMINDERS
• Always use tap water.
• If tap water is too hard, use distilled or demineralized water to avoid
the risk of mineral deposits or sediment from forming.
• Do not add detergents, perfumes, oils or other chemical substances.
Using Your Floor Steamer
• To emit steam from the
Steam Nozzles, push the
trigger on the Handle.
*IMPORTANT*
The Steam Nozzles are meant
to be used in steam “bursts”
and should never be used on
a sustained basis. The Steam
Nozzles will loosen especially
difcult debris and will assist
in cleaning hard to reach
areas such as oor edges.
NOTE:
Your Steamer will not need the
Boiler to be relled for up to
20-25 minutes.
The Floor Steamer will stop producing steam when the Boiler is em-
pty. When this happens unplug and store unit or rell with water per
instructions (1D).
NOTE: If the Floor or Carpet Pad become too wet or too dirty, replace with a
clean, dry Pad and continue cleaning.
C. Using Steam (continued)
