INSTALLING HANDLES
Lifting handles are furnished with larger models (MT17F-U1, MT27F-U1, MT35F-U1,
MT45F-U1, MT60F-U1, MT60F-U1-C, MT80F-U1), and are packed loose inside the
refrigerator. They are to be installed using the screws and tapped holes provided.
CONNECTING TO POWER SOURCE
120 VOLTS A.C. OPERATION IN YOUR HOME;
Your refrigerator needs so little power that it may be connected to any A.C.
receptacle in your home. To do this, set the thermostat control knob to "OFF"
and insert the square plug of the A.C. cord in the connector on the refrigerator
and the standard plug in a wall socket in your home. The power
consumption is less than a standard light bulb.
12/24 VOLT D.C. OPERATION IN YOUR FOUR WHEEL DRIVE, CAR, BOAT,
TRAILER, RV. ETC.
Battery voltage varies with the type of car you own. Most cars, trucks and boats
use a 12 volt system. Your refrigerator needs either a 12 volt or a 24 volt
battery with a negative ground.
FOR MODELS MT17F-U1 and MT27F-U1 and MT35F-U1 and MT45F-U1
Set the thermostat control knob to "OFF" and insert one end of the D.C. cord
(provided with the refrigerator) into the connector and the other end into the cigarette
lighter socket of your car. In most passenger cars, the lighter is on the dashboard.
Pull out the lighter and insert the refrigerator plug.
NOTE : When not using the refrigerator, remove the plug from the cigarette lighter
socket to prevent discharge of your car battery.
Most 4-wheelers install a dedicated power socket in the rear of the vehicle to make
connecting the refrigerator easier. Some SUV’s and mini vans already have these
installed.
FOR MODEL MT60F-U1, MT60F-U1-C and MT80F-U1 only
Set the thermostat control knob to "OFF" and insert one end of the D.C. cord
(provided with the refrigerator) into the connector of the refrigerator and connect two
wires from the battery to the other end of the D.C. cord. The MT60F-U1, MT60F-U1-C
and MT80F-U1 do not come standard with a cigarette lighter adaptor.
