person before using it again. Non-observance could cause a fatal electric shock!
• Never attempt to open the housing yourself.
• Do not place any kind of object into the inside of the housing.
• Do not use the appliance with wet hands, on a damp floor or when the appliance itself is wet.
• Do not touch the plug with wet or damp hands.
• Check the cord and the plug regularly for any possible damage. If the cord or plug is damaged, it
must be replaced by the manufacturer or a qualified person in order to avoid a hazard.
• Do not use the appliance if it is dropped or otherwise damaged or if the cord or plug are damaged.
In the case of damage, take the appliance to an electrical repair shop for examination and repair if
necessary.
• Never attempt to repair the appliance yourself. This could cause an electric shock.
• Do not allow the cord to hang over sharp edges and keep it well away from hot objects and naked
flames. Remove the plug from the socket only by holding the plug.
• For extra protection it is possible to fit the electric household installation with a fault current
breaker with a rated breaking current of not more than 30mA. Ask your electrician for advice.
• Make sure that there is no danger that the cord or extension cord may inadvertently be pulled or
cause anyone to trip when in use.
• If an extension cord is used it must be suited to the power consumption of the appliance,
otherwise overheating of the extension cord and/or plug may occur.
• This appliance is not suitable for commercial use nor for use in the open air.
• Never leave the appliance unattended while it is in use.
• Children cannot recognise the dangers involved in the incorrect use of electrical appliances.
Therefore never allow children to use household appliances without supervision.
• Always remove the plug from the socket when the appliance is not in use and each time before it
is cleaned.
• Danger! Nominal voltage is still present in the appliance as long as the appliance is connected to
the mains socket.
• Switch the appliance off before disconnecting from the mains.
BEFORE INITIAL USE
• Remove all packing materials.
• Clean the appliance as described in
Cleaning and maintenance
.
• The appliance must be allowed to stand for at least 2 hours before connecting it with an outlet so
that the cooling agent can sink. Otherwise the refrigerating compressor would become damaged.
OPERATION
• Open the lid (1) and take out the ice basket (2).
• Fill the water tank below the ice basket (2) with normal temperatured water. The water level must
not reach the ice basket. Insert the ice basket (2) and close the lid (1).
• Connect the power plug (5) with an appropriate outlet. Choose the desired ice cube size with the
AUSWAHL button (8). The corresponding control lamp flashes:
Ice cube size Control lamp
small S (13)
medium M (12)
large L (11)
• Press the START button (7). The ice cube production begins.
• It will take about 8 to 12 minutes to obtain the ice cubes. Do not open the id (1) during the ice
cube production. The production might be checked through the control window in the cover.
• The control light WASSERMANGEL lights up in case there should not remain sufficient water in
the water tank. Stop the ice cube machine by pressing the STOPP button (9). Fill in water as
described above. The appliance should not be started again for at least 3 minutes in order not to
damage the refrigerating compressor.
• Once the ice basket (2) is filled, the ice cube production will be stopped by the measuring probe
(3) and the control lamp EIS (14) will light up. Stop the ice cube machine by pressing the STOPP
button (9). Remove the ice with the ice scoop (4) from the ice basket (2). Restart the ice cube
machine by pressing the START button (7).
• If the transport scoop should be blocked during operation, the control lamps EIS (14) and
WASSERMANGEL (10) will flash simultaneously. Switch off the appliance and remove ice pieces
from the transport scoop area. Wait at least 3 minutes before you switch on the appliance again.
• For hygienic reasons, the water in the water tank should be replaced every 24 hours. Then the
appliance should be cleaned as described in care and maintenance.
• To remove water from of the water tank, please open the residue water discharge (6) in a
clockwise direction and let remaining water run out completely. Re-close the residue water
discharge (6).
CLEANING AND MAINTENANCE
• Pay attention to the
Security advice
.
• Lift out the ice basket (2) and clean it with thin washing liquid solution under warm running water.
• Clean the appliance, its interior and its components with a moistened cloth and a thin washing
liquid solution. The appliance should be completely dried, if it will not be used for a longer period
of time.
• After using the ice cube machine, leave the lid (1) open so that mildews and bacteria will not
develop.
• Leave the lid (1) open, if the appliance will not be used for a long period of time.
• Do not use any abrasive cleaning agents or hard cleaning tools.
• Never use benzene or solvents for cleaning.
TECHNICAL DATA
Operational voltage : 230V~ 50 Hz
Power consumption : 150 Watt
Interior capacity : 2 l
Cooling agent type : R134a
Dimensions (W x H x D) : approx. 340 x 410 x 365 mm
Weight : 15 kg
INSTRUCTIONS ON ENVIRONMENT PROTECTION
Do not dispose of this product in the usual household garbage at the end of its life
cycle; hand it over at a collection point for the recycling of electrical and electronic
appliances. The symbol on the product, the instructions for use or the packing will
inform about the methods for disposal.
The materials are recyclable as mentioned in its marking. By recycling, material
recycling or other forms of re-utilization of old appliances, you are making an important contribution
to protect our environment.
Please inquire at the community administration for the authorized disposal location.
GUARANTEE AND CUSTOMER SERVICE
Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has
occurred during production or transportation, please return the device to your dealer. In addition to
statutory legal rights, the purchaser has an option to claim under the terms of the following
guarantee:
For the purchased device we provide 2 years guarantee, commencing from the day of sale. During
this period we will remedy all defects free of charge, which can be demonstrably attributed to
material or manufacturing defects, by repair or exchange.
Defects which arise due to improper handling of the device and malfunctions due to interventions
and repairs by third parties or the fitting of non-original parts, are not
covered by this guarantee.
5 6
GB
GB
GB
GB
approved
elta GmbH
Carl-Zeiss-Str. 8
63322 Rödermark
