708676
4
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
4
7.
Perform the test using the same steps described in Operation & Testing section
above to ensure the unit is working properly. By walking into the protected area
with coverage of 110 degrees, the detector will now be triggered each time it
senses movement. Note that the detector can only be triggered once every 30
seconds when mounted on the wall.
Maintenance
Low Battery: When the battery becomes low, the LED will flash red when
motion is detected to indicate low battery condition to the user.
Troubleshooting
The troubleshooting table lists some possible causes and solutions. Please contact
your original retailer or nearest service center if the below solutions cannot solve
your problem.
Symptom
Cause of Failure
Recommendation
LED cannot be displayed
1.
Run out of battery
power.
2.
Check if reverse battery
polarity.
1.
Replace a new battery.
2.
Refit the battery with
correct polarity.
The detector is not working
1.
The PIR detector cannot
communicate with the
gateway.
2.
Check if the detector is
out of order.
1.
Place the PIR Detector
closer to the gateway.
2.
Send the device in for
repair and do not open it.
After the two-minute warm
up is completed, the
detector does not work
and LED flashes on and
off repeatedly at with an
interval of 2 seconds
1. Check if detector has
completed binding with
Gateway
1. Remove the battery and
follow the steps for
“Manual binding”.
Reset to Factory Settings
1.
Press and hold the link key on the PCB for 3 or more seconds, and the
detector LED will start to flash.
2.
Press and hold the link key for 6 or more seconds within 30 seconds until the
LED turns off. The device is now reset back to factory mode
Specifications
Battery
CR123A 3.0V 1700mAh Lithium Battery
Operating Temperature
-10°C to 40°C
Warm Up Time
About 2 minutes
PIR Detection Coverage
Wall-Mounted:
Up to 10m x 110
°
(at 1.8m mounting height & 25
°
C)
Operating Frequency
868MHz
** Specifications are subject to change without notice.
WARNING:
Do not dispose of electrical appliances as unsorted municipal waste, use separate
collection facilities.
Contact your local government for information regarding the collection systems
available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances
can leak into the groundwater and get into the food chain, damaging your health
and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to
take back your old appliance for disposal at least for free of charge.
A501112384R02
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elro AS80PR11 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elro AS80PR11 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,5 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info