708653
1
Verklein
Vergroot
Pagina terug
1/3
Pagina verder
INTRODUCTION ELRO HOME PIR PET-IMMUNE MOTION SENSOR AG40PP11:
The PIR Pet-immune Motion Sensor AG40PP11 is designed for use with the AG4000 ELRO Home
Alarm System.
PIR Motion Sensor: Tamper
PIR sensors are designed to detect movement. This sensor features Test
pet immunity however, meaning that your pet moving around will not cause
false alarms.
Installing your home PIR Motion Sensor:
First, the battery has to be inserted into the device. To do this, first unscrew the screw at the bottom of
the sensor so you can remove the back plate. After removing the back plate, place the CR123A 3V
lithium battery in the sensor in the way shown in the picture above. Under normal conditions, the battery
will typically have a life of 3 years. After powering on, the PIR will warm-up for 2-3 minutes. The LED
will flash during this time. When the warm-up has finished, the LED will stop flashing. Next press and
hold the small black test button for at least two seconds to make the PIR detector enter test mode. When
in test mode, if you walk around the area the unit is covering, the LED will flash for 0.5 second (normally,
the LED will not flash when it detects movement). The control panel will also be notified of movement
being detected. If no movement is detected for more than 3 minutes, the PIR detector will exit test mode
and enter normal mode again.
Note: Under test mode the LED will flash when the PIR detector is triggered. The LED flash in test mode
only lasts for 0.5 second. When the unit has a low battery, the LED will flash for one second. In normal
mode the PIR will only send a new signal after two minutes have passed since being triggered.
Pet immunity:
The sensor comes with a pet immunity mechanism immunity mechanism so that small pets or other
animals will not trigger the detector and cause false alarms. The mechanism works by detecting
height/length, therefore a pet that is taller than 60cm or longer than 90cm will trigger the PIR motion
sensor. You can see this in the image shown below.
Mounting the PIR motion sensor:
When determining where to place the detector, there are various factors to consider:
1. The detector must not be placed facing a window that lets in direct sunlight. PIR detectors are
not suitable for use in sunrooms or greenhouses.
2. Do not place the detector in a place where a ventilator is in its line of sight.
3. Do not place the detector directly above a heat source (e.g. fire, radiator, boiler, etc.)
4. Where possible, mount the detector in the corner of a room, so that the logical path of an
intruder would cut across the detection pattern. PIR detectors are better at detecting
movements across their field of view, than at detecting movement directly towards or away
from the unit.
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elro AG40PP bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elro AG40PP in de taal/talen: Engels als bijlage per email.

De handleiding is 0,25 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Elro AG40PP

Elro AG40PP Gebruiksaanwijzing - Nederlands - 6 pagina's

Elro AG40PP Gebruiksaanwijzing - Deutsch - 3 pagina's

Elro AG40PP Gebruiksaanwijzing - Français - 3 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info