741483
1
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
ITALIANO
SENSORE OTTICO DI FUMO VIA RADIO BIDIREZIONALE FO31WL
WIRELESS BIDIRECTIONAL SMOKE DETECTOR FO31WL
DETECTEUR FUME RADIO BIDIRECTIONELLE FO31WL
Fig. 1
Fig. 2
CARATTERISTICHE TECNICHE
Alimentazione........................... 2 pile Lithium/Manganese Dioxide da 3V
tipo CR123A - Formati: CR17345 (IEC),
5018LC (ANSI)
Portata radio............................. Fino a 400 m in aria libera
Copertura.................................. 40 m
2
Pressione acustica buzzer........ 85 dB (A) @ 3 m
Autonomia della pila ................. 2 anni, in normali condizioni d’impiego
Temp. di funzionamento........... 0 °C ÷ +40 °C
Umidità relativa......................... 10 ÷ 85 %
Materiale involucro ................... ABS colore RAL9003
Grado di protezione involucro... IP40 / IK02
Dimensioni (Ø x h).................... 136 x 68
INSTALLAZIONE
1) Aprire il sensore ruotando la calotta in senso antiorario, ed inserire la pila
(esclusivamente al momento dell’acquisizione) rispettando le polarità (fig. 1).
Per l’acquisizione e la configurazione del sensore, fare riferimento al Manuale di
Installazione del Sistema WL31.
2) Fissate la base del sensore a soffitto utilizzando le predisposizioni “A” (fig. 2),
posizionandola in modo che la freccia “B” (fig. 2) sia in direzione della centrale.
3) Chiudete il sensore allineando la tacca presente sul fondo con quella sul
sensore e ruotando la calotta in senso orario.
SOSTITUZIONE PILE
Per sostituire le pile, aprire il sensore rimuovere le stesse, quindi
sostituirle e consegnare quelle scariche presso smaltitori autorizzati.
Il corretto inserimento delle pile dev’essere fatto come segue:
premere contemporaneamente i pulsanti (Fig.1-B) ed inserire le pile nel
vano preposto (Fig.1-A) prestando attenzione alla loro polarità ed
effettuandone una discesa parallela rispetto al circuito stampato.
La programmazione effettuata viene mantenuta anche dopo la
sostituzione delle pile.
ATTENZIONE !!! PERICOLO D’ESPLOSIONE SE LA PILA E’
SOSTITUITA CON ALTRA DI TIPO SCORRETTO.
Le pile esauste al Litio sono dei rifiuti speciali con codice di
classificazione CER 160605 e il loro smaltimento a fine ciclo di vita, è
regolamentato da precise disposizioni di legge.
ENGLISH FRANCAIS
TECHNICAL CHARACTERISTICS
Powering................................... 2 3V Lithium/Manganese Dioxide batteries
type: CR123A - Formats: CR17345 (IEC),
5018LC (ANSI)
Radio range .............................. Up to 400 m in open air
Covering range ......................... 40 m
2
Buzzer acoustic pressure ......... 85 dB (A) @ 3 m
Battery's life .............................. 2 years under normal conditions of use
Working temperature ................ 0 °C ÷ +40 °C
Relative humidity ...................... 10 ÷ 85 %
Casing material......................... ABS color RAL9003
Casing protection degree ......... IP40 / IK02
Dimensions (Ø x h)................... 136 x 68
INSTALLATION
1) Open the detector by turning the cover counterclockwise, insert the
battery (at the time of acquisition only) according to the proper pole
positions (fig. 1). For detector acquisition and configuration refer to WL31
System Installation Manual.
2) Secure the detector base to the ceiling using presetting “A” (fig. 2), and
position it by directing arrow “B” (fig. 2) towards the central unit.
3) Close the detector by aligning the notch on the bottom with the notch on
the detector and turn the cover clockwise.
BATTERY REPLACEMENT
To replace the batteries, open the detector and remove the batteries.
Replace them and hand over the dead ones to authorized disposal
centers.
Batteries correct insertion is by:
simultaneously pressing the pushbuttons (Fig. 1-B) and putting the
batteries into prearranged opening (Fig. 1-A) while paying attention to their
polarity and dropping it parallel to printed circuit.
Programming performed will be kept unvaried although batteries have
been replaced.
WARNING !!! DANGER OF EXPLOSION IF THE BATTERY IS
REPLACED WITH ANOTHER OF THE WRONG TYPE. FOLLOW THE
INSTRUCTIONS FOR ELIMINATING USED BATTERIES. Lithium
batteries are classed as special waste code E.W.C. 160605 and their
disposal at the end of their lifecycle is regulated by legal provisions.
CARACTÉRISTIQUES TECHNIQUES
Alimentation …………………………………..2 piles au lithium / dioxyde de
manganèse de 3 V, type
CR123A - formats : CR17345
(IEC), 5046LC (ANSI)
Portée radio………………………………….. Jusqu’à 400 m en plein air
Couverture……………………………………. 40 m
2
Pression acoust. de l’avertisseur son……… 85 dB(A) @ 3 m
Autonomie de la pile…………………………. 2 ans, dans des conditions
d’emploi normales
Temp. de fonctionnement…………………... 0 °C ÷ +40 °C
Humidité relative………………………………10 ÷ 85 %
Matériel du boîtier………………… ………….ABS couleur RAL9003
Degré de protection du boîtier……………….IP40 / IK02
Dimensions (Ø x h)…………………………...136 x 68 mm
INSTALLATION
1) Ouvrez le détecteur en tournant la calotte dans le sens anti-horaire et
introduire la pile (exclusivement lors de l’acquisition) en respectant les
polarités (fig. 1). Pour acquérir et configurer le détecteur, consultez le
manuel d’installation du système WL31.
2) Fixez la base du détecteur au plafond en utilisant les emplacements
prévus « A » (fig. 2), et en la positionnant de façon à ce que la flèche
« B » (fig. 2) soit orientée vers la centrale.
3) Fermez le détecteur en alignant l’encoche présente sur le fond avec
celle du détecteur et en tournant la calotte dans le sens horaire.
REMPLACEMENT DES PILES
Pour remplacer les piles, ouvrez le détecteur et en retirez les piles épuisées,
puis remplacez-les et remettez-les aux centres d'élimination autorisés.
L’introduction correcte des piles doit être réalisé comme suit :
appuyer en même temps sur les boutons (Fig. 1-B) et introduire les piles
dans le logement correspondant (Fig. 1-A), en faisant attention à leur
polarité et en les pressant vers le bas, parallèlement au circuit imprimé.
La programmation effectuée est maintenue même après le remplacement
des piles.
ATTENTION !!! DANGER D’EXPLOSION SI LA PILE EST REMPLACEE
PAR UN AUTRE TYPE. Nous rappelons que les piles au Lithium sont
des déchets spéciaux - code de classification CED 160605 et que
leur élimination, en fin de vie, est réglè par des dispositions de loi.
0682
A
B
A
B
ELKRON S.p.A.
Via Cimarosa, 39 – 10154 Torino (TO) – ITALY
Tel. +39(0)113986711 – FAX +39(0)113986790
www.elkron.it
mail to: info@elkron.it
IS3115-AB
DS80SD40-001_LBT80175
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Elkron FO31WL bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Elkron FO31WL in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 0,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info