831167
22
Verklein
Vergroot
Pagina terug
1/231
Pagina verder
GB
- 22 -
6.1.4 Using with connectivity (Fig. 13)
The “connectivity” function enables the vacuum
cleaner to be switched on/o via the detection of
vibrations.
Connect the suction hose (10) to the vacuum
cleaner connection of your electric tool and fasten
the transmitter (43) to the suction hose (Fig. 13).
Make sure that the transmitter is fastened secure-
ly. If the vibrations are too low, fasten the transmit-
ter directly to the electric tool.
Set the On/O /Vacuum setting switch (2) to po-
sition I or II and set the connectivity switch (42)
to position I. The vacuum cleaner will switch itself
on as soon as you switch on the electric tool and
vibrations are generated. When you switch o the
electric tool, the vacuum cleaner will switch o
after a pre-set delay.
6.2 Dry vacuuming
Use the pleated lter (18) for dry vacuuming (see
point 5.2). The dirt bag (14) can be tted in additi-
on when removing particularly stubborn dirt (see
point 5.3).
Always ensure that the lters are securely seated!
6.3 Wet vacuuming
For wet-vacuuming, use the foam lter (15) (see
point 5.2).
Check that the lter is securely seated at all
times!
Water drain screw (Fig. 1)
To make the tank (7) easier to empty after wet va-
cuuming, it is tted with a water drain screw (17).
Open the water drain screw (17) by turning it
counter-clockwise and drain the liquid.
When wet vacuuming, the oating safety switch
(Fig. 3/5) closes when the maximum tank level
is reached. In doing so, the suction noise of the
equipment will change and become louder.
You must then switch o the equipment and em-
pty the tank.
Danger!
The wet and dry vacuum cleaner is not suitable
for the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam
lter.
6.4 Blowing
Connect the suction hose (10) to the blow con-
nector (9) on the wet and dry vacuum cleaner.
6.5 Cleaning the appliance head (1/3)
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the plas-
tic parts in the appliance.
6.6 Cleaning the container (1/7)
The container can be cleaned with a damp cloth
and some soft soap or under running water, de-
pending on the amount of dirt.
6.7 Cleaning the lters
Cleaning the pleated lter (Fig. 2a)
Clean the pleated lter (18) regularly by carefully
patting it and cleaning it with a ne brush or hand
brush.
Cleaning the foam lter (2a)
Clean the foam lter (15) with a little soft soap un-
der running water and allow it to air-dry.
Cleaning the lter (Figs. 11a-11b)
The lter (26) should be checked at regular inter-
vals and cleaned if necessary.
1. Remove the lter cover (34) (Fig. 11a).
2. Take out the lter (26) (Fig. 11b)
3. Clean the lter by tapping it or blowing it out.
4. Assemble in reverse order
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery before starting any
cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible.
We recommend that you clean the equipment
immediately after you use it.
7.2 Servicing
At regular intervals and before each use, check
that the lters in the wet and dry vacuum cleaner
are securely tted.
Anl_TP_VC_36_30_S_Auto_SPK13.indb 22 14.09.2021 09:57:59
22

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Einhell TP-VC 36-30 S Auto bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Einhell TP-VC 36-30 S Auto in de taal/talen: Alle talen als bijlage per email.

De handleiding is 2,74 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info