654244
31
Verklein
Vergroot
Pagina terug
1/33
Pagina verder
ΕNGLISH
Instruction manual ELEKTRONIKA II PROFI
30
11 TROUBLE SHOOTING
Problem Possible Cause Troubleshooting
The grind is not fine enough.
Use a finer grind.
Tamp the ground coffee more
firmly.
Reduce the brewing pressure.
The coffee is too old. Use fresh coffee.
Little or no crema on top of the
coffee.
There is too much chlorine in the
water.
Use a chlorine filter.
The amount of ground coffee is not
enough.
Use the right amount of coffee:
Approx. 7 g of coffee for each cup.
Little or no crema on top of the
coffee.
The shower screen is dirty. Clean the brew group.
The grind is too fine.
Increase the grind.
Tamp ground coffee only slightly.
Increase the brewing-pressure.
Sparse coffee dispensing, only drop
by drop.
There is too much ground coffee.
Use approx. 7 g of coffee for every
cup.
The grind is not fine enough. Reduce the grind.
The coffee is old. Use fresh coffee.
The amount of ground coffee is not
enough.
Use approx. 7 g of coffee for each
cup.
Weak “body”.
The shower screen is dirty. Clean the shower screen.
The beans are improper. Use another coffee bean.
Foam instead of crema.
The setting of the coffee grinder is
not suited for the coffee beans in
use.
Adjust the coffee grinder (When
changing the coffee beans, changing
the grind can also be necessary.)
The buttons of the control panel
flash: there is not enough water in
the water tank.
Refill water.
Water was refilled, the buttons of
the control panel flash.
Switch on/off the machine.
Make sure that the floater in the
water tank is in the correct position.
(The side of the floater with the
magnet point must face towards the
inside of the machine. The floater
itself must be inserted with the
magnet point on the lower part of
the floater side.)
The water tank is not seated
properly.
Seat the water tank properly.
The machine is switched on, but the
machine does not work.
Machine in use with direct water
connection, but switch in
position “0” (=position water tank).
Machine does not take in water.
Switch to position “1” (=position
direct water connection).
The machine does not stop working
and takes in air.
Machine in use with water tank, but
switch in position “1” (= position
direct water connection).
Switch to position “0” (=position
water tank).
Filter holder is not fixed properly. Fix the filter holder properly.
Filter holder/ brew group is
dripping.
Group gasket is broken.
Change group gasket and shower
screen.
Different quantities of coffee.
Different grinding degree.
Irregular tamping.
Different doses when preparing 1
espresso, 2 espresso etc.
Different types of coffee.
Make sure to maintain the same
parameters.
31

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ecm Elektronika II Profi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ecm Elektronika II Profi in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 2,4 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info