782671
35
Verklein
Vergroot
Pagina terug
1/38
Pagina verder
35
PLEASE NOTE: i12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
English
Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
Troubleshooting
If the error code remains shown:
Close the hot water faucet.
Take the proper action shown below and
attempt operation of the water heater
again.
If the error code is still shown:
Turn o the hot water faucet.
Take note of the error code displayed and
call the customer service assistance number
in the “If You Need Service” section.
When an error code is displayed:
• Close the hot water faucet.
• Wait for 5 minutes before turning the unit
on again.
• Open the hot water faucet.
NOTICE: If an error code other than those listed
below is displayed, immediately turn o the hot
water faucet, take note of the error code, turn
o the switch on the remote control and call the
customer assistance number.
CAUTION: For your safety DO NOT attempt repair of gas piping, remote control,
burners, vent connectors or other safety devices. Refer repairs to qualied service
personnel.
CAUTION: Make certain power to water heater is “OFF” before removing protective
cover FOR ANY REASON.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring
errors can cause improper and dangerous operation. VERIFY PROPER OPERATION
AFTER SERVICING.
Error Code Guide
Error
Code Error Description Possible Cause What To Do
E0 Hot water sensor
failure
Junction port loose,
Short circuit Call for Service
E1 Ignition system failure
The gas valve is not opened
or fully opened, Water
shut-o valve is not open,
Junction port loose
Check and open gas fully,
Check and open water valve,
Call for Service
E2
There is ame when
no
water coming in
Electric circuit problem Call for Service
E3 Over-heating
protection
Dry Combustion, Problem of
over heating controller Call for Service
E4 Cold water
temperature sensor
problem with sensor,
problem with sensor’s plug
or socket, none of the above
replace the sensor, x it,
replace the computer board
E5 Pressure Switch Motor problem, Voltage of
power supply is too low Call for Service
E6 Over-heating
Gas pressure is too high,
Water shuto valve is not
fully opened, The
temperature is set too low
Check shut-o valve and
open fully, Increase
temperature setting
E7 solenoid valve
open circuit of the valve,
short circuit of the valve,
none of the above
connect the valve, replace the
valve, replace the computer
board
E8 vent pipe block vent pipe is blocked clean the pipe
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Eccotemp i12 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Eccotemp i12 in de taal/talen: Engels als bijlage per email.

De handleiding is 7.11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info