611875
4
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
7-5-2013 4 ebode eSD18
4. Using the Smoke Detector
Installing the battery
Connect a 9-volt battery to the connector. Do not use a rechargeable battery. The battery
will fit only one way. Be sure the battery connector is securely attached. Place battery into
battery pocket (see picture 1.2).
Alarm
A continuous beeps will sound when smoke is detected. One “chirp” every 30 seconds will
be an indication that the battery is low or the unit is malfunctioning. In case of a low
battery level, replace the battery as soon as possible. As you install the battery, the unit
will sound “chirp” to indicate the battery is installed properly.
The red LED will flash in conjunction with the alarm beep. I.e., the red LED will flash during
an alarm and a low battery mode chirp.
Testing the detector
Press the test button on top of the smoke detector or on the inside “Test Button 1” (see
picture 1.2) for several seconds to test the detector’s electronics. The alarm will sound.
Note, Do this weekly to ensure correct functioning.
Technical Specifications
Input Voltage: DC 9V
Static Current: <30uA
Alarm Current: <30mA
Operating Temperature: -10° ~ 50°C
Operating Humidity: <95% RH
Installation Method: Ceiling mounted
Detecting Area: 60m2 (with 4 meters height)
LED Frequency: once per 5 seconds
Alarm Output: Sound & Flash Alarm
Sensor: Infrared Photocell
Sensitivity: m=0.15 0.5dB/m
Low Voltage Prompt: 7.5V
5. Registering the Detector with the BSS880 Home Protector & Console
The detector can be registered in two different modes, being either as a Remote or as a
Sensor, the difference between these mode is explained below.
Remote mode
When set to Remote mode, the detector will act as a remote, which means it will always
trigger an alarm as soon as a fault is detected. The state of the console, being Armed or
Disarmed, will make no difference. You can change the mode with the “Mode Selector
Switch” showed in picture 1.2. Modes: Up is Remote Mode, down is Sensor Mode. When the
detector stops detecting smoke it will disarm the consoles alarm automatically.
Sensor mode
In Sensor mode the smoke detector will act as a door/window sensor. When the alarm is
disarmed and smoke is detected the smoke detector will sound an alarm and the console
will sound a chime (if enabled in the console). When the alarm is armed in “Away Mode
and the smoke detector detects smoke both the alarm of the smoke detector and the alarm
of the console will sound (console will only sound alarm if enabled in the console). The
alarm of the console needs to be disabled with either the consoles PIN code or a remote.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Ebode eSD18 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Ebode eSD18 in de taal/talen: Nederlands, Duits, Engels, Frans, Spaans, Noors als bijlage per email.

De handleiding is 0,69 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info