703743
4
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
+49 38851 314650 *)
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
All rights reserved.
Do not use corrosive or abrasive cleaning products to clean the
product. They could damage the surface. When needed, wipe
the product off with a soft, dry cloth.
Product contents
1 x daylight lamp with built-in control panel
1 x adapter
1x remote control including 3 V type CR2032 button cell
(inserted)
Remote control
1 AN/AUS switch (ON/OFF)
2 Warm white light
3 Tageslicht (daylight)
4 Farbe (colour)
5 Farbwechsel (colour
change), all colours
6 Control panel for colour
selection (12 mixed col-
ours)
7 RGB setting (red, green,
blue)
8 Increase/decrease the
brightness
Start-up
ATTENTION!
The plastic foils and bags pose a suffocation hazard! Keep
children and animals away from the packaging material.
Unpack the product contents and make sure that they are
complete (see chapter “Product contents”) and check for any
damages from transport. If the product, plug or mains cord
exhibits damages, do not use the product (!); instead contact
customer service.
Before you use the product, remove all packaging material and
any labels located on the product and which serve to provide
protection during transport or are for advertising purposes.
Changing the remote control battery
The battery for the remote control has already been inserted.
You only have to remove the transport guard.
1. The battery compartment is lo-
cated on the narrow side of the
remote control. Pull it out as
shown.
2. Remove the empty battery
and insert a 3 V battery (type
CR2032). The positive terminal
must point upwards.
3. Place the battery compartment back in the remote control so
that it locks in place.
Use
Please note that the colour settings are mixed colours. For
this reason, the colour tints may exhibit minor deviations.
1. Connect the adapter to the port in the base of the lamp.
2. Insert the mains plug in a properly installed socket that is easily
accessible.
3. Turn on the lamp by pushing the button AN (on) on the remote
control or An/Aus (On/Off) on the control panel of the lamp.
4. Select the desired colour. To do so, push the colour button (4)
rst and then the corresponding colour button on the remote
control.
5. You can also select the desired effect and push the
corresponding button (2, 3, 5) on the remote control or push the
button M (mode) on the control panel of the lamp several times.
6. Set the desired colour brightness using the buttons to
increase / decrease the brightness on the remote control or
using the arrow buttons (˄ increase, ˅ decrease) on the control
panel.
7. Push the button AUS (off) on the remote control or push An/
Aus (On/Off) on the control panel again to turn off the lamp.
Troubleshooting
If the product is not working properly, please check whether you
are able to rectify the problem yourself.
Do not attempt to repair a defective electrical product
yourself!
If the light does not switch on, check
whether the product is properly connected with the socket.
whether the socket is defective. Try another socket.
the fuse for your mains connection.
whether the battery in the remote control is empty.
Variations
Article number Model number
wood look oak Z 05797 SL7375O
wood look brown Z 05811 SL7375M
wood look beech Z 05818 SL7375B
brass look Z 05825 SL7375C
chrome look Z 05837 SL7375N
white Z 07375 SL8025T
Technical data
Colour temperature:
warm white: approx. 3000 K
daylight: approx. 5500 K
Voltage supply:
adapter input: 100 – 240 V, 50/60 Hz
output: DC 12 V, 1 A
lamp: DC 12 V
remote control: 3 V (1 x 3 V battery, type CR2032)
Output: 5 W
Disposal
The packaging material is recyclable. Dispose of the
packaging in an environmentally-friendly manner and make
it available to the collection service for recyclable materials.
Dispose of the product in an environmentally-friendly
manner. It does not belong in the household garbage.
Dispose of it at a recycling centre for old electric and
electronic equipment. For more information, please contact
the administration in your community.
Batteries and rechargeable batteries must be removed and
disposed of separately before disposing of the product.
To protect the environment, batteries and rechargeable
batteries may not be disposed of together with normal
household waste. Instead they must be turned in at
appropriate collection points. Please also observe applicable
statutory provisions regulating the disposal of batteries.
1
2
3
4
5
8
7
6
push
pull
DLTL_V2_06_2016
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Easymaxx Z05818 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Easymaxx Z05818 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,23 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info