732845
5
Verklein
Vergroot
Pagina terug
1/39
Pagina verder
98
can set the hygrostat in the range between 40%
and 70%. With every touch it will increase with 10%
in the following order: 40% > 50% > 60% > 70%
> CO (continuous). Using continuous mode will
deactivate the hygrostat and the device will run
at continuous speed. When the hygrostat is set
above the actual humidity, the device will operate
in high speed until the desired humidity has been
reached. When the hygrostat is set below the
actual humidity, the device will not humidify. After
setting the hygrostat, the display will show the
ambient humidity.
Timer
Press the button to activate the timer setting.
With every touch the timer will increase with one
hour in the following sequence: 1h > 2h > 3h > 4h
> 5h > 6h > 7h > 8h > 9h > 10h > 11h > 12h
> 00h (o). Once the timer is activated, the device
will automatically shut down after the set timer has
been completed.
Night mode
Press the button to activate night mode. Once
pressed, the LED matrix display will show “ZZZ” for
5 seconds. In night mode, all buttons are disabled
except the night mode and power button. The
device will operate in SL (slow) speed mode.
Power
Touch the button to switch on the device.
After turning on the device, the LED matrix display
will light up for 1 second and shows “Hi!” for 2
seconds after which it will display the current
status followed by the ambient humidity. When
you turn on the device for the rst time, it will
activate medium wind speed and turn to low
wind speed after 3 seconds. The humidication
setting will remain active. Touch the POWER button
again to put the device in stand by followed by a
conformation beep. The LED matrix will show “OFF”
and turn o the device in 2 seconds.
Humidity output / wind
speed
When you turn on the device for the rst time,
it will activate medium wind speed. Touch the
button to switch between wind speeds. The LED
matrix display will show the corresponding wind
speed in SL (slow), LO (low), MI (medium) and HI
(high).
Hygrostat
Touch the button to set the desired ambient
humidity. When you turn on the device for the rst
time, the continuous mode will be activated. You
EN
Press the button again to deactivate night
mode. The LED matrix display will show “ZZZ”
and go back into normal operation mode according
to the hygrostat setting.
Dry run protection
After turning on the device it will check for 1
second if there is sucient water remaining in the
water tank. In case of lack of water, the device will
activate dry run protection mode and the motor
will stop working. The LED matrix display will show
“NO!” and “Lo” alternating every second. In this
mode, all buttons are disabled except the power
button. Please turn o the device, ll the water
tank and press the power button to switch on the
device again.
Note: It may take a couple of seconds before
the water from the water tank lls up the water
tray. You will hear a water dripping sound, which is
normal. Once the device has recognized the water
tray is lled, it will start operating.
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Duux DXAW03 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Duux DXAW03 in de taal/talen: Nederlands, Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 7,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info