471271
4
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
4
STARTING CHARGE
Linear current will be supplied to NiCd and NiMH batteries during charge. Once the charger detects that the battery’s
voltage has reached peak, it will automatically stop fast charge and start trickle charge.
1. For 6- or 7-cell power batteries, connect the battery to the charger’s output lead. Make sure the polarities of the
battery and charger’s leads match (red charger wire to red battery wire, black charger wire to black battery wire). Skip
to step 3.
2. For 4-, 5-, or 8-cell radio batteries, insert the battery’s plug in the RADIO BATTERY JACK on the front edge of
the charger. Make sure the battery’s black or brown wire is on the right side when inserting into the jack. Refer to the
INPUT POWER section on page 2 for details about charging 7- or 8-cell batteries. If a 7- or 8-cell battery does not
appear to have reached full peak, attempt to peak charge the battery again by disconnecting it from the charger and
then re-connecting.
CAUTION: Make sure the charge current setting is safe for your battery to prevent overheating of
the cells. “AAA”, “AA”, “A”, or “2/3A” size batteries generate heat more quickly than large sub-C
batteries. It’s NOT recommended to charge batteries having a rated capacity less than 600mAh with
this charger. Failure to follow these recommendations could permanently damage your battery!
Disconnect the battery from the charger IMMEDIATELY if the battery becomes hot!
3. Fast charge will start automatically when the charger recognizes the battery is connected to the output. The LED will
turn on at this time.
4. When the charger detects the battery has reached peak, fast charge will end and trickle charge will begin automatically.
The LED will flash TWICE every five seconds, indicating trickle charge is in process and the battery is ready for use at
this time. The charger will remain in trickle charge mode until the battery is disconnected from the charger.
The trickle charge current value is set automatically at a rate
being the fast charge current setting divided by 20, as shown
in the chart at right.
To manually stop charge at any time, disconnect the battery
from the charger. The LED should return to flashing once
every five seconds.
A backup safety timer is built into this charger to automatically stop fast charge if peak is not detected in 90 minutes.
If you attempted to charge a battery and later found the LED flashing once every 2 seconds, this means the 90
minute safety timer stopped charge (not the peak detection circuit). You could try to peak charge the battery again by
disconnecting and then reconnecting it to the charger. Refer to the Troubleshooting Guide for more details.
If the LED flashes in a pattern different than described above, refer to the ERROR INDICATORS AND
TROUBLESHOOTING GUIDE for details.
CARE & HANDLING OF NIMH BATTERIES
Do not to allow NiMH batteries to overheat. Disconnect overheated batteries from the charger immediately and
allow to cool.
Store NiMH packs with some voltage remaining on the cells (refer to battery supplier).
It is important to recharge NiMH batteries immediately prior to use, as they have a high self-discharge rate.
TRICKLE CHARGE RATE
Fast Charge Current Approx. Trickle Current
1A 50mA
2A 100mA
4A 200mA
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Duratrax Onyx 100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Duratrax Onyx 100 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,31 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info