499407
12
Verklein
Vergroot
Pagina terug
1/13
Pagina verder
12
Fig. 30
49
50
Fig. 31
52
51
Fig. 32
54 53 55
Cleaning the sunshower and the
acrylic plates
Use a moist cloth to clean the sunshower . The acrylic plates
should also be cleaned at regular intervals. Use only sol-
vent-free, non-caustic and non-aromatic cleaning agents.
To remove the acrylic plates, pull each plate forward from
its position, gripping the profile bars on the side (49) from
behind as shown in Fig. 30. Bend the plate (50) slightly
toward the inside. Then press the plate down and out of
the mounting frame grooves on the sides. The plate can
now be cleaned on both sides.
Replacing UV tubes and starters
To replace tubes and starters, first remove the acrylic
plates as described above.
The UV tubes in your tanning system must be replaced
after a certain number of operating hours.
The effective service life of the UV low-pressure tubes is
about 500 hours. Please ensure that only original
replacement parts are used when replacing tubes and
starters. Replacement parts can be ordered from
customer service or your local dealer. Please indicate
the system number (see ID plate). This applies to orders
for all replacement parts.
UVA low-pressure tubes (53) are removed/inserted by
turning them 90! in their sockets (54) both above and
below and pulling them forward. When inserting new
tubes, please ensure that the contact pins on the tubes
are fitted properly into the sockets.
After cleaning, replace each plate in the following manner:
Set the lower edge of the plate on the pin (51), grip the
side profile bars and press the outer edge of the plate
(52) against one edge of the mounting frame.
Then bend the plate slightly toward the inside and press
until the opposite edge locks into place on the other edge
of the mounting frame. Fig. 31.
Technical Specifications
Tan Can 4000
Lamp tubes: 33 x 100 W UVA reflectorlamps
30 x 25 W spaghettilamps
Nominal power output: 4700 W
Circuit breakers: 3 x 16 A
Nominal voltage: 3N AC 400 V
Power cable: 5 x 1,5 mm²
Dimensions:
Outside dimensions: Æ 1.1 m, height 2.45 m
Inside dimensions: Æ 0.88 m, height 2 m
Exhaust hose: Æ 300 mm
System exhaust configuration
Exhaust air should be removed from your sunshower via
a hose. Please take the following points into account with
regard to the configuration of the exhaust system.
Outside temperature has a considerable impact on
system operation. Ideally, outside temperature should
be 28! with a relative humidity of 70%. Use only 300-mm
hose for the exhaust line. Ideally, exhaust hose should
lead in a straight line up and away from the cell. Bends in
the hose generate air-flow resistance. Avoid 180! bends
in all cases. Given a straight exhaust line configuration,
exhaust hoses can be as long as 2 m without the need
for an additional blower unit. If the exhaust line is longer
than 2 m or has bends, the addition of an auxiliary blower
unit is recommended in order to ensure effective exhaust
air removal. Hose output diameter should not be reduced
at any point in the exhaust line, as this may result in air
blockage.
Starters (55) are located at the upper ends of the tubes
and are removed/inserted by turning them 90° and out
of their sockets. Fig. 32.
Lamp tubes: 48 x 160 W UVA reflector tubes
Nominal power output: 8500 W
Circuit breakers: 3 x 16 A
Nominal voltage: 3N AC 400 V
Power cable: 5 x 1.5 mm²
Dimensions:
Outside dimensions: Æ 1,1 m, height 2,45 m
Inside dimensions: Æ 0,88 m, height 2 m
Exhaust hose: Æ 300 mm
Tan Can 8000
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dr. Kern Tancan 4000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dr. Kern Tancan 4000 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,27 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info