Tune to a DAB+ preset station
In DAB+ mode
1. Press and release the Preset button, Preset Recall s1 is displayed and the name or frequency of the
station stored there, or 'Empty if no previous station has been stored
2. Press the Prev. or Next button to scroll to the Preset location and station that you would like to listen to
(1-10)
Press the Select button, the radio will instantly tune to that station and begin to play.
Note: If no DAB+ station has been stored under the preset button, Preset Empty will be displayed, then the radio
will revert to the previously selected radio station after a few seconds.
Using Your FM Radio
Press the Power/Mode button (if in DAB mode) to switch to FM mode. The display will show FM
Tuning a FM station
1. Extend the telescopic antenna.
2. Press and hold either Prev. or Next button to scan up or down the frequency range. When a station is
found the scan will stop and play the located station. or press the Scan button to search FM stations.
3. You can fine tune the frequency by pressing either Prev. or Next button to advance 0. 05MHZ with each
press.
Factory Reset
To reset to factory settings please follow the steps below:
1. Press Power/Mode button to turn on and long press Menu button.
2. Then appear full scan or scan setting, press Prev or Next button, into the menu selection until you find
System, press the Snooze/Select button to confirm the selection
3. Press Prev or Next button to find Factory Reset, press the Snooze/Select button to confirm, and then
press Prev or Next button to select <YES>, press the Snooze/Select button to confirm
4. Then LCD appears System reset, and a few seconds later the display shows System reset OK
Note: performing a factory reset will remove any presets stored in both DAB+ and FM.
The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so,
simply reset the product to resume normal operation by following the instruction manual. In case the
function could not resume, please use the product in other location
