13
INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control;
• Insert two R03 “AAA” 1.5V batteries in the correct position (see
instructions inside the battery compartment);
• Replace the cover.
If the remote control unit is replaced or disposed of, the batte-
ries must be removed and discarded in accordance with cur-
rent legislation as they are harmful to the environment.
SETTING THE TIME
After having inserted the batteries, the
clock on the display flashes until the
time is set.
Proceed as follows:
• Press the or button until the correct time is reached. Hold
the button down to run rapidly through first the minutes, then the
tens of minutes and then the hours.
• Once the correct time has been reached, press the SET button to
confirm.
If you need to change the time later, press the SET button, then set as
described above.
To cancel the settings programmed on the remote control and resto-
re the original settings, press the RESET button lightly with the point of
a pencil or pen.
USING THE REMOTE CONTROL UNIT
The first part of the controls on the remote control are the same as
those on the control panel of the appliance.
You should therefore refer to the instructions in the chapter Operating
from the control panel to turn the appliance on and select the ope-
rating mode (AIR CONDITIO-
NING, DEHUMIDIFYING, FAN or
SMART) and the fan speed.
The following section descri-
bes the additional functions
corresponding to the controls
on the bottom part of the
remote control.
BOOST FUNCTION
Ideal for the summer to cool rooms rapidly.
Activate by simply pressing the button.
The appliance operates in air conditioning mode at maximum fan
speed. While this function is selected, it is not possible to set the tem-
perature or change fan speed.
✔
