C ollection
38
The coffee does not
come out of the spouts,
but rather around the
service door.
•The holes in the spouts are clogged
with dry coffee.
•The mobile drawer inside the service
door is blocked and cannot swing.
• Scrape the holes with a needle (see paragraph 16.1, Fig.29).
•Thoroughly clean the mobile drawer, particularly near the
hinges to ensure they are free to swing smoothly.
The milk does not run out
of the milk spout.
•The intake tube is not inserted or is
inserted incorrectly.
• Insert the intake tube in the rubber washer in the milk con-
tainer lid (fig. 19).
The milk is not well fro-
thed.
•The milk container lid is dirty. • Clean the milk lid as described in paragraph 16.3.
The milk contains bub-
bles or squirts out of the
milk spout.
•The milk is not cold enough or is not
skimmed or semi-skimmed.
•You are recommended to use skimmed or semi-skimmed
milk at refrigerator temperature (about 5°C). If you are still
not getting the required results,try changing brand of milk.
PROBLEM CAUSE SOLUTION
A) If your appliance comes fitted with a plug, it will incorporate a 13
Amp fuse. If it does not fit your socket, the plug should be cut off
from the mains lead, and an appropriate plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug after remo-
ving the fuse: do not insert in a 13 Amp socket elsewhere in the
house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must
be protected by a 15 Amp fuse.
If the plug is a moulded-on type,the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to
BS 1362. In the event of losing the fuse cover, the plug must NOT
be used until a replacement fuse cover can be obtained from
your nearest electrical dealer. The colour of the correct replace-
ment fuse cover is that as marked on the base of the plug.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following
code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not correspond with the
coloured markings identifying the terminals in your plug, proceed as fol-
lows:
The green and yellow wire must be connected to the terminal in the plug
marked with the letter E or the earth symbol or coloured green or
green and yellow.
The blue wire must be connected to the terminal marked with the letter
N or coloured black.
The brown wire must be connected to the terminal marked with the let-
ter L or coloured red.
