28
Empty the grounds container and clean thoroughly, making sure all residues deposited on the bottom are
removed.
IMPORTANT: when removing the drip tray, the grounds container MUST be emptied, even if it is not com-
pletely full. If this is not done, when next making coffee the grounds in the container may exceed the maxi-
mum level and block the appliance.
NOTE 8: while the appliance is running off coffee, never remove the water tank. If it is removed, it will not
be possible to make the coffee and the appliance will display:
GROUND TOO FINE ADJUST MILL AND
INSERT WATER SPOUT AND PRESS OK
To turn the appliance on again, you must insert the water spout (fig. 4), press the button and run off
water from the spout for a few seconds.
7 CHANGING THE QUANTITY OF COFFEE IN THE CUP
The appliance is factory preset to automatically deliver the following quantities of coffee:
- short coffee (40 ml) (when the button is pressed);
- normal coffee (80 ml) (when the button is pressed);
- long coffee (120 ml) (when the button is pressed);
To change these quantities, proceed as follows:
1. press the button corresponding to the quantity you want to change ( , or ) for at least 8
seconds then release until the message "PROGRAM QUANTITY" is displayed and coffee is delivered;
2. when the coffee in the cup reaches the required level, press the same button again to memorise the new
amount.
The appliance is now re-programmed with the new settings and displays: READY.
8 REGULATING THE COFFEE MILL
The coffee grinder is preset in the factory to prepare coffee correctly and should not require regulating ini-
tially.
However, after making the first coffees, if you find that coffee delivery is either too fast or too slow (in drips),
the grinding coarseness regulator can be adjusted (fig. 12).
Turning it 1 click clockwise speeds up coffee delivery (without drips).
Turning 1 click anticlockwise slows down delivery giving a creamier appearance to the coffee.
These adjustments will only be evident after at least 2 cups of coffee have been run off.
The grinding coarseness regulator must only be turned when the coffee mill is on.
Turn one click anticlockwise to obtain slower delivery and a
creamier appearance (finer ground coffee).
Turn one click clockwise for faster delivery (not a drop at a time)
(coarser ground coffee).
(Coffee has been used to factory test the appliance and it is therefore completely normal for there to be tra-
ces of coffee in the mill. This appliance is however guaranteed to be new).
