745210
10
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
12
5.3.2 USING LFE INPUT
When connecting your DALI SUB P-10 DSS to smaller speakers, e.g. the DALI EPICON 2, we
recommend a crossover point of approximately 80 Hz. This must be entered in the menu system
of your (pre-) amplifier. You might need to enter the ‘small’ setting when selecting type of front
speakers in the AV receiver menu.
Connecting larger speakers (typically floor-standing front speakers) will allow you to choose a
lower crossover point, and to define your speakers as ‘large’ in the menu system.
If in doubt about the capacity of your speakers, we recommend setting the crossover point quite
high, defining your speakers as small, and finally reducing the crossover point to the lowest
possible position while maintaining an even bass with no drop-outs.
5.4 CINEMA / HIFI MODE
DALI SUB P-10 DSS allows you to choose between two sound modes, one which is optimized
for watching movies, and another for listening to music. See Figure 3.
For a realistic and powerful rendering of e.g. explosions in a movie, you should set the sound
mode to CINEMA. This will amplify the lowest frequencies to ensure a realistic experience.
For a neutral and very linear performance, you should set the sound mode to HIFI. This will
ensure a precise rendering of all the details of the music, while optimizing the integration with
your front speakers.
To toggle between the two sound modes, simultaneously press the ‘+’ and ‘-’ buttons on the
back of the amplifier.
5.5 POWER
The POWER switch is the main ON/OFF switch. We recommend switching ‘OFF’ the subwoofer
when it is not to be used for extended periods. When changing connections, always disconnect
the mains voltage from the subwoofer. We recommend that you ALWAYS turn ‘OFF’ the POWER
switch on the rear side of the subwoofer BEFORE turning off the mains switch.
5.6 ON / STAND BY MODE
The subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an
input signal is detected (given that the POWER is set to ‘ON’ and the POWER MODE switch is
set to ‘AUTO’). When the subwoofer is ‘ON’, the ON/STANDBY LED will light up green. If an input
signal is not detected for approximately 20 minutes, the subwoofer will go into standby mode
and the ON/STANDBY LED will light up red.
Setting the POWER MODE switch to ‘MANUAL’ means that the subwoofer can only be switched
‘ON’ or ‘OFF’ by means of the remote control.
10

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Dali SUB P-10 DSS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Dali SUB P-10 DSS in de taal/talen: Engels als bijlage per email.

De handleiding is 1,66 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info