657563
69
Verklein
Vergroot
Pagina terug
1/75
Pagina verder
| 57 56 |
MTB/ ROAD BIKE/ TREKKINGMTB/ ROAD BIKE/ TREKKING
Risk of Personal Injury and
Material Damage!
Spinning road wheels can cause injuries
to your hands.
Never put your hand near a spinning road
wheel.
Come to a complete standstill before carry-
ing out works on, or around, the wheels.
In order to do this, lift the rear of the bicycle
up, actuate the corresponding shift lever
and turn the crank by hand in the riding
direction until the chain is placed on the
smallest pinion.
Brake the road wheel until it comes to a
complete standstill (see chapter 8.7).
3. Open the brake (only applies to rim bra-
kes, not to disk brakes)
a) As for rim brakes with cable control
(e.g. from Shimano):
Press the brake shoes together with one
hand and remove the cable guide from the
yoke.
b) On Magura: hydraulic rim brakes:
Move the xing lever over and remove the
entire brake assembly including brake boos-
ter from the brake sockets.
Please make sure you do not lose any dis-
tance washers that may come loose.
4. On front wheel with hub dynamo (if
tted):
Remove the push-t connector between the
dynamo and cable.
5. Loosen the wheel hubs.
Open the quick release on your road wheel
(see also Chapter 8.8 Quick Releases)
Raise the rear of the bike, operate the shift
lever concerned and turn the crank in the
drive direction until the chain lies correctly
on the smallest sprocket.
Turn the locknut enough to allow sucient
room on the axle.
With other types of clamping.
Loosen the clamp as per the accompanying
parts instructions
6. Remove the road wheels from the frame
and forks.
Front wheel: Lift the bike up by the handle-
bars and withdraw the road wheel from the
front fork dropouts.
Rear wheel: lift the bike up slightly at
the back and press the gear mechanism
backwards. In this position, push the rear
wheel gently in the direction of the dropout
openings.
11.1 Fit and remove road wheels
Risk of Personal Injury and
Material Damage!
Incorrectly tted road wheels can lead to
dangerous riding situations, falling, acci-
dents and material damage.
You must have your dealer demonstrate
tting and removing your road wheels.
Practise this job at least once under his
supervision and control.
Only remove and t the seat post and saddle
if you are sure you have mastered this job.
Risk of burns!
After long descents, the bicycle rims and
brake disks can get very hot.
Do not touch the rims or brake disks imme-
diately after a descent.
Let the rims and brake disks cool down
before you touch them.
In order to check the temperature, touch the
rims and brake disks very briey with your
nger. If they are hot, wait a few minutes
and repeat the test until the rims and brake
disks have cooled down.
Danger of material damage!
Hydraulic brakes must under no circumstan-
ces be operated after removing the road
wheel!
If your bike has a disk brake, use the man-
datory transportation wedges supplied for
that purpose for transportation following
removal of the road wheel.
Remove these immediately prior to retting
the road wheels.
Please comply with the accompanying parts
instructions here.
Risk of Personal Injury and
Material Damage!
Rim brakes only:
when tting and removing, the brake
blocks can get twisted.
When tting the road wheels, please note
that the brake blocks are correctly positi-
oned (see Chapter 7.8).
If these are not correctly positioned, please
contact a specialist workshop.
For transportation you may remove and
later replace the road wheels on your bike
if these are tted with quick releases.
If your bike has rim brakes please be
careful that you do not change the po-
sition of the brake blocks with the tyre.
This could happen especially in the case
of large-volume tyres. If the tyre does
not pass easily between the brake caliper
blocks, let a sucient amount of air out
of them.
Then inate the tyres afterwards to the
correct pressure.
11.1.1 All categories/series except the
category racing bike/triathlon
1. Remove the front wheel rst
(continue with 3).
2. Switch to the smallest pinion of the rear
wheel’s sprocket cassette (see chapter
8.6).
69

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Cube-MTB

Zoeken resetten

  • Halllo,
    Zie het framenummer nergens staan ! Net nieuwe fiets zit geen sticker op staat alleen iso4210-2 en pending system onder frame. Verzekering zegt is geen framenummer.
    Het is een Cuba imam race . Als iemand het weet graag? Gesteld op 16-1-2022 om 13:06

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cube MTB bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cube MTB in de taal/talen: Duits als bijlage per email.

De handleiding is 8,82 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Cube MTB

Cube MTB Gebruiksaanwijzing - Nederlands - 37 pagina's

Cube MTB Gebruiksaanwijzing - English - 37 pagina's

Cube MTB Gebruiksaanwijzing - Français - 37 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info